Tri Delta Ind. Inc. GPS-1 Circuit Board

The Tri Delta Ind. Inc. GPS‑1 Circuit Board is a compact industrial control module used in servo drive and motion‑control applications. Common failures on this board include burned or cracked surface‑mount components, especially the power MOSFETs and voltage regulator ICs, as well as intermittent I/O due to solder joint fatigue; older units may also exhibit capacitor electrolyte leakage. Begin troubleshooting by verifying that the supply rails (±12 V, 5 V) are within spec with a multimeter, then visually inspect for burn marks or cracked traces on the power section and check the status LEDs for error codes. Finally, test the I/O pins against expected logic levels while cycling the unit to confirm proper signal integrity.[oss-gpt-20b]

Need your Tri Delta Ind. Inc. repaired or tested?

We specialize in the repair and refurbishment of high-end industrial control electronics and power systems like this unit.

📞 Call Now: 1 (336) 969-0110

Free Estimates • Industrial-grade testing • Nationwide Service

Call to Purchase AI Services — help us build the next Grace Blackwell GX10 node.

Industrial AI Hardware Recovery — Free Diagnostic • Pay Return Shipping Only

[oss-gpt-20b]

We reclaim and repair GPUs and industrial AI hardware (cards, PSUs, fan modules, VRM boards). Free estimate — you only pay return shipping if you decline.

📞 Call: 1 (336) 969-0110 ✍️ Start Free Diagnostic

Free Estimates • Industrial-grade testing • 1-Year Warranty • Nationwide Service


Other Repaired Units by Tri Delta Ind. Inc.

Tri Delta Ind. Inc. GPS-1 Circuit Board

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.