ProtoTrak Stop/start button Repair Service

Professional diagnostic and board-level repair service for this ProtoTrak Stop/start button.

ProtoTRAK is a CNC controller used on industrial milling and lathe machines; the stop/start button is part of its safety interface that halts axis motion in all operating modes (program run, GO TO, Power Feed, tool change). Common failures include mechanical wear or broken contacts from frequent use, electrical shorting to the motor drive circuits, or loss of signal due to cable damage. First‑check steps: verify power and ground continuity on the button circuit, inspect for visible contact wear or corrosion, and review any error codes or log entries indicating a stop/start fault in the controller software. Post Comment

Need your ProtoTrak Stop/start button repaired?

Ship your unit to our North Carolina repair shop for component-level diagnostics and a repair estimate. We service industrial control electronics and power systems nationwide.

• ⚙️ Board-level diagnostics – Troubleshooting beyond simple module replacement
• 🔁 Clear approval process – No repair begins without your approval
• 🧰 Expert Technicians – Decades of board-level experience
• ✅ 1-Year Warranty – Included with completed repairs

Start a Repair Request   Call 1-336-969-0110

Nationwide service • Industrial-grade testing • 1-year warranty on completed repairs

Owner-Operated • Practical Pricing • 1-Year Warranty • Nationwide Service

Other Repaired Units by ProtoTrak