DCOM CB100462‑01 Rev. B is a 3/4‑wire multiplexer PCB used in industrial gate‑controller and power‑distribution systems, typically mounted on the main control chassis of DCOM gate‑drive units. Common failure modes for this board include burnt or tripped MOSFETs, degraded Schottky diodes, and damaged connector pins that cause intermittent signal loss or over‑current protection trips. First‑check diagnostics: verify input voltage and power‑rail continuity with a multimeter; inspect the board for visual signs of component damage (burn marks, cracked solder joints); and review any error codes from the host controller to isolate the affected channel.[oss-gpt-20b] |
Need your DCOM repaired or tested?
We specialize in the repair and refurbishment of high-end industrial control electronics and power systems like this unit.
📞 Call Now: 1 (336) 969-0110
Free Estimates • Industrial-grade testing • Nationwide Service
⚡ Call to Purchase AI Services — help us build the next Grace Blackwell GX10 node.
We reclaim and repair GPUs and industrial AI hardware (cards, PSUs, fan modules, VRM boards). Free estimate — you only pay return shipping if you decline.
Free Estimates • Industrial-grade testing • 1-Year Warranty • Nationwide Service
DCOM CB100455-02 Circuit Board
DCOM Cb100462-01 Rev. B Circuit BoardIndustrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.
Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.