Fujitsu MPG3102AT Hard disc

Fujitsu MPG3102AT is a 3.5‑inch, 10 GB IDE hard drive rated at 5400 RPM with an ATA‑100 interface and a 512 KB cache. Common failure modes include spindle motor or bearing wear leading to audible noise, read/write errors from bad sectors, firmware corruption, and power‑supply voltage spikes causing controller damage. First‑check diagnostics: verify the IDE cable and connector for continuity and proper pin alignment; confirm the drive’s Vcc/Vss voltages are within spec (±5 % of 5 V) using a multimeter; run an S.M.A.R.T. health check or use `smartctl` to review error logs and sector counts. If errors persist, perform a surface scan with `badblocks` and consider firmware re‑flash if the drive reports checksum mismatches.[oss-gpt-20b]

Need your Fujitsu repaired or tested?

We specialize in the repair and refurbishment of high-end industrial control electronics and power systems like this unit.

📞 Call Now: 1 (336) 969-0110

Free Estimates • Industrial-grade testing • Nationwide Service

Call to Purchase AI Services — help us build the next Grace Blackwell GX10 node.

Industrial AI Hardware Recovery — Free Diagnostic • Pay Return Shipping Only

[oss-gpt-20b]

We reclaim and repair GPUs and industrial AI hardware (cards, PSUs, fan modules, VRM boards). Free estimate — you only pay return shipping if you decline.

📞 Call: 1 (336) 969-0110 ✍️ Start Free Diagnostic

Free Estimates • Industrial-grade testing • 1-Year Warranty • Nationwide Service


Other Repaired Units by Fujitsu

Fujitsu PSU17A Power supply
Fujitsu MPG3102AT Hard disc
Fujitsu FI-5120C scanner

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.