Hydravlic WM2 Liner Amplifiers

The Hydravlic WM2 Liner Amplifier is an electro‑hydraulic linear amplifier that converts a low‑pressure hydraulic signal into high‑pressure output for precise actuator control. Common failure points in this class of units include power supply degradation (voltage drop or ripple), internal relay or contact wear, and contamination of the hydraulic fluid leading to valve sticking. Initial diagnostics should verify the input voltage and ground integrity, inspect the PCB for burnt components or cracked traces, and check the hydraulic line pressure with a pressure gauge; if error codes are present, review the diagnostic LED status or serial log for fault flags.[oss-gpt-20b]

Need your Hydravlic repaired or tested?

We specialize in the repair and refurbishment of high-end industrial control electronics and power systems like this unit.

📞 Call Now: 1 (336) 969-0110

Free Estimates • Industrial-grade testing • Nationwide Service

Call to Purchase AI Services — help us build the next Grace Blackwell GX10 node.

Industrial AI Hardware Recovery — Free Diagnostic • Pay Return Shipping Only

[oss-gpt-20b]

We reclaim and repair GPUs and industrial AI hardware (cards, PSUs, fan modules, VRM boards). Free estimate — you only pay return shipping if you decline.

📞 Call: 1 (336) 969-0110 ✍️ Start Free Diagnostic

Free Estimates • Industrial-grade testing • 1-Year Warranty • Nationwide Service


Other Repaired Units by Hydravlic

Hydravlic WM2 Liner Amplifiers

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.