GE/Fanuc A06B-6087-H130 power supply Repair Service

Professional diagnostic and board-level repair service for this GE/Fanuc A06B-6087-H130 power supply.

The GE/Fanuc A06B‑6087‑H130 is a PSM‑30 power supply module used in Alpha Series CNC systems to convert mains AC into the DC rail voltages that feed servo amplifiers and spindle drives. Common failure points for this unit include blown fuses or internal protection trips, degraded electrolytic capacitors causing ripple or voltage sag, and overheating of the transformer windings or rectifier bridge. First‑check diagnostics should verify the incoming AC supply and line frequency, test the output DC rails against spec with a multimeter, inspect all fuses and electrolytics for signs of failure, and review any error codes from the CNC controller that reference power supply status. Post Comment

Need your GE/Fanuc A06B-6087-H130 power supply repaired?

Ship your unit to our North Carolina repair shop for component-level diagnostics and a repair estimate. We service industrial control electronics and power systems nationwide.

• ⚙️ Board-level diagnostics – Troubleshooting beyond simple module replacement
• 🔁 Clear approval process – No repair begins without your approval
• 🧰 Expert Technicians – Decades of board-level experience
• ✅ 1-Year Warranty – Included with completed repairs

Start a Repair Request   Call 1-336-969-0110

Nationwide service • Industrial-grade testing • 1-year warranty on completed repairs

Owner-Operated • Practical Pricing • 1-Year Warranty • Nationwide Service

Other Repaired Units by GE/Fanuc