Welcome to Applied

We repair a wide range of Applied Equipment.

Ask questions, or 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Free estimate with an approved repair
• Practical owner-operated pricing
• Purchase orders and Net 7–30 terms for approved business accounts

Send the model and part number with a description of the failure for a repairability review.

Comments for Applied

📝 Maurice Bennink said:

Hi:I acquired an old 2-1/2 Sterling extruder and would like to remove the screw. Could you tell me how the screw is held in place and/or how to remove the screw?Thank you in advance,Maurice Bennink— Purchase or Repair:

➡️ Reply Applied Epi Optys

📝 John Elkins said:

I am emailing on behalf of the Agriculture Dept of Stephen F. Austin State University. We have a Torchmate CNC plasma cutter table and the motor driver blew out one of its axiss. We are still functioning on the other 2 axiss. Torchmate quoted me almost 700 dollars for a new driver and cables. Our department, like most state funded schools is very limited on what we have money in our budget for; and repairs to this machine after only being online for roughly a year are not part of that limited budget. How much for repairing the motor driver? What is the normal estimated turn around time for this sort of thing, it is right in the middle of a very important project.If I need to get numbers off of the box please let me know. You can call me between 10-8 M-F, calling is usually the fastest way to reach me. Thank you, John ElkinsPresident of Ag Engineering Technology Club.— Purchase or Repair:

➡️ Reply Applied Robotics

📝 Brodersen said:

Could the Applied Kilovolts HW50/2P high voltage power supply be repaired or should I look into buying a replacement? Trying to get this checked off my to-do list.— Purchase or Repair:

➡️ Reply Applied Kilovolts

📝 Sal Zanghi said:

Applied Motion 1000-053e drive or board failure detected during rounds. Need immediate attention to troubleshoot and fix.— Purchase or Repair:

➡️ Reply Applied

📝 Michael Donnelly said:

The Applied Weighing LP1 Programmer is showing a CAL ERR error message. Need urgent assistance to get the equipment back up and running.— Purchase or Repair:

➡️ Reply Applied Weighing