Welcome to Autonumerics Inc

unofficial service & repair forum

We repair a wide range of Autonumerics Inc Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

No repair summaries available yet for this manufacturer.

Comments for Autonumerics Inc

📝 John Adelmann said:

I have been running a Shizouka 3 axis mill for a particular job for 15 years and have run into a X motor control problem. The X axis vibrates in place at any feed rate right now. I have swapped 2 stepper cards and both x and y motor drives in the mainpower box with no changes in result. The motor itself turnsrelatively freely without powered up. What would be my next step. I have I/O boards from a 1970double spindle unit available but I hesitate to switch them out.John

➡️ Reply Autonumerics Inc.