Welcome to Dresser-Rand

unofficial service & repair forum

We repair a wide range of Dresser-Rand Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

No repair summaries available yet for this manufacturer.

Comments for Dresser-Rand

📝 joaquim.aresta said:

i have a compressor the need some parts were i weel be able to get parts from serie #66As/n 4018x7067

➡️ Reply Dresser-Rand

📝 joaquim.aresta said:

i have a compressor the need some parts were i weel be able to get parts from serie #66As/n 4018x7067

➡️ Reply Dresser-Rand

📝 shane said:

What parts are you looking for ?? I,ve found alot of them .....Most of these places like Dresser-Rand won,t help you theyll just pass you off to someone else

➡️ Reply Dresser-Rand

📝 Sam said:

looking for basic info or specs on a dresser compressor.only have partial tag infothis is the info I can read 400serial # 453X1 238LER(assuming Leroi)Dresser (look like industries) IncSindey Ohio U.S.A.

➡️ Reply Dresser-Rand

📝 NORM BLAIS said:

I RECENTLY PURCHASE A USED DRESSER COMPRESSOR MODEL#550-A SERIAL#4017X6925 WITH THE PULLEY,THE UNIT HAS HAD VERY LITTLE USE.THE PROBLEM IM HAVING IS THE SMALL COPPER LINES LEAVING THE 2 HEADS GOING TO THE BASE,THEY HAVE BEEN RIP OFF AND I DONT KNOW WHERE THEY ALL GO.MY PLAN IS TO USE THIS UNIT IN MY GARAGE WITH A MAX. PRESSURE OF 140 PSI.,WHAT SIZE OF MOTOR DO I NEED,SO COULD YOU SEND A SHEET WITH THE DIRECTION OF THOSE LINES AND THE SPEED IT NEED TO TURN, WHAT TYPE OF OIL ETC. THANK-YOU ...NORM FAX#705-474-3943 MAILING ADDRESS 1522 MAIN ST.WEST NORTH BAY ONTARIO CANADA P1B2X3

➡️ Reply Dresser-Rand

📝 Jody Hotchkiss said:

I was told that I need special tool to remove valves. Why such a big deal? I cant afford to take chance to rebuld my shit if theirs going to be complacations. Give me some ideas to work on this. This is my money maker, cant afford to sit.

➡️ Reply Dresser-Rand