Welcome to Ferro

We repair a wide range of Ferro Equipment.

Ask questions, or 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

No repair summaries available yet for this manufacturer.

Comments for Ferro

📝 John H Smith said:

I need cables (encoder and motor) to connect a DARC S12(35-060800) to a AC servomotor(HD142e6-130, 35161701).The cable part number are:70-25060070-251500

➡️ Reply Ferrocontrol

📝 Ed Puckett said:

We have an Elumatec MGS245 saw with an E550 controller. The controller uses a Kontron MOPSlcd6 PC/104 processor and a Ferrocontrol fieldbus card (all of these are German companies). I think that the fieldbus card is out. I think that the part number for the card is 91027100, but Im not sure.We need either a replacement card or to have the existing card and/or controller repaired. I have pictures of the card and controller that I can email.

➡️ Reply Ferrocontrol

📝 Brian Borst said:

We have an Elumatec MGS244 saw with an E550 controller. The controller uses a PC/104 processor and a Ferrocontrol fieldbus card (all of these are German companies). I think that the fieldbus card is out. I think that the part number for the card is 91027100, but Im not sure.We need either a replacement card or to have the existing card and/or controller repaired.

➡️ Reply Ferrocontrol

📝 An, Yuping said:

Type: s02-00-2e, current controll error

➡️ Reply Ferrocontrol

📝 Eric Haffner said:

We have an Elumatec SBZ122, and the monitor has gone dark.I would like to repair the display instead of replacing it (cost).Monday evening I installed a new display panel, and it worked on Tuesday, but not on Wednesday. I suspect the power supply, however the power supply is controlled by another module.I can find no evidence of any component failure.I feel the components are relatively easy to replace.I would be willing to send pictures, if you supply an email address.The machine is running, as I have connected an external monitor.Thank you,Eric HaffnerPlease CC emails to my personal address, because many time I am unable to get to a computer at work.ehaffner@trulite.com / eric.thered@yahoo.com

➡️ Reply Ferrocontrol

📝 Biswajit said:

Subject Urgent Request for Repair Information on Ferrocontrol D-32049herfordHi ,Im reaching out on behalf of a colleague who is experiencing issues with a Ferrocontrol D-32049herford unit. Unfortunately, the specific problem is unknown, but they need a replacement quickly. Could you kindly provide repair information for this model as soon as possible?Thank you for your

➡️ Reply Ferrocontrol