Welcome to Heimann

unofficial service & repair forum

We repair a wide range of Heimann Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

No repair summaries available yet for this manufacturer.

Comments for Heimann

📝 Aurelio B. Tormes said:

We need the following:1. Check/validate if our unit is still Calibrated, it was not calibrated for the past 5 years.2. Do you supply a brass calibration block? what we use is steel calibration block. Our operating cylinder hardness ranges from 180 to 220 vickers, which calibration block is needed for our unit?3. Do have a local contact here in the Philippines?4. Send us quotation regarding calibration of our unit and the test block.We ddo expect for your prompt reply.Thanks,Leo TormesEngineering & Facilities Manager.

➡️ Reply Heimann

📝 R.M.SHARMA said:

Microdur harness tester we have sent for repairing to Heimann but it is nor repairable do, help us.

➡️ Reply Heimann

📝 Dorothy Wu said:

We need your repair service support.1) Pls provide us your mailing address and contacts in order to send our unit to you for repair service.2) Send us quotation after inspection of the unit.Your prompt reply is highly appreciated.Thanks,Dorothy Wu

➡️ Reply Heimann