Welcome to Hema

unofficial service & repair forum

We repair a wide range of Hema Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

40+ years of experience repairing Industrial & Commercial units
Certified Senior Industrial Electronics Technician
Ability to do Reverse Engineering
No job to big or small
Fast turn around time on most units
Quality of work comes before profit!
Old Fashion Customer Service is always the right policy
Extended warranty
Fair Estimates
Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

🛠️ Common AI Repair Summaries 🏭

🔧 Hema 98889 (Motor)

The Hema 98889 motor is an industrial electronic component used for converting electrical energy into mechanical energy. It is designed for high efficiency and reliability in various industrial applications. Common failures in this motor model include overheating due to excessive load or poor ventilation, bearing wear leading to noise and vibration, and electrical faults such as short circuits or insulation breakdown. Regular maintenance and monitoring of operating conditions are recommended to prevent potential failures and ensure optimal performance.

Part:
Est. Repair Price: $250.00 (est.)

Comments for Hema

2 comments found.

📝 jerry seamans said:
Do you have a repair kit (seals and o-rings) available for a hema hydraulic pump?Numbers on pump: 1P1 / 1P1- 128 180903 RE197623 (john deere #)
➡️ Reply Hema

📝 TACSHEN INVESTMENTA said:
JUST HEARD ABOUT HEMA WAITING FOR RESPONSE
➡️ Reply Hema

📝 jamie said:
I need a power steering seal kit for the hema pump, 1997/1998
➡️ Reply Hema

📝 kandkfarmequipment.com (Wendell) said:
I have a hema hyd. pump j.d. #re197623 that I need to repair if possible or a refurbished pump. please call or e-mail if you can help. Customer cant afford one from j.d. Thanks Wendell ph 803-564-6517 803 608 1676
➡️ Reply Hema

📝 Lloyd Peterson said:
Do you have a seal for the output shaft on a Hema pump John Deere # RE68887. Please advise Thank you Lloyd
➡️ Reply Hema

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.