Welcome to KO

We repair a wide range of KO Equipment.

Ask questions, or 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Free estimate with an approved repair
• Practical owner-operated pricing
• Purchase orders and Net 7–30 terms for approved business accounts

Send the model and part number with a description of the failure for a repairability review.

Comments for KO

📝 Jim said:

Kouwa KMV-150-M16-A throws an E8 code. Ambient pressure is around 140psi at 75 degrees. Unit will run for about 3 -5 minutes and throw the code. Current to the compressor is about 3.6 amps. Is this a good value? On page 8 of the check out procedure the term thermal setting value for current is listed in the E8 alarm procedure. What is the normal thermal setting value for current draw?What are the normal operating pressures and current load for this unit when running properly? Any ideas on what needs to be replaced?— Purchase or Repair:

➡️ Reply Kouwa