We repair a wide range of Peak Equipment.
Ask questions, or 1-336-969-0110 for faster service.
Use the search bar above to find specific manufacturers.
The Peak PEAK715VL-HT-HC board is a high-temperature industrial electronics board designed for rugged environments. It features high-quality components and robust construction to withstand extreme conditions. Typical failures in this board may include solder joint failures due to thermal stresses, component degradation from prolonged exposure to high temperatures, or circuit traces breaking under mechanical strain. Regular maintenance and monitoring are recommended to ensure reliable operation.
Hello,Im a technician at Navistar Inc. in Melrose Park, Il. We use Peaktronics DMC-101 motor controllers to control air dampers for our engine testing facility. Weve always had a problem where the air damper is commanded by us, to open to 100%. The correct 4-20ma signal is sent to the controller and the damper moves to 100%, but wont return to the other direction, when commanded to do so. We verify the command current at the Peaktronics board, but both open and closed LEDs stay on and the damper freezes. We try adjusting the board according to specs without luck, and finally replace the DC-101 and this temporarity fixes the problem, but a month later, the same thing happens. When we measure the MOTOR 1 and MOTOR 2 wires at the DC-101, we get 24volts on both of them. This cant be right because, the motor is being commanded in both directions then. Do you folks have any thoughts on why we might be going through so many boards? Could we be wiring the unit wrong? Thank you.➡️ Reply Peaktronics
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.
Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.