Welcome to Penn

We repair a wide range of Penn Equipment.

Ask questions, or 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Free Estimates
• Low Prices

No repair summaries available yet for this manufacturer.

Comments for Penn

📝 expofeCex said:

Hello everyone First of all sorry that I write in this topic but I have some technical problem with the use of this forum. When Im trying to enter in the appropriate topic, I received a 404 error Its about the only topic in which I was able to enter. Do you have the same problems? Whats going on?— Purchase or Repair:

➡️ Reply Penny & Giles

📝 William Cherrington said:

Im looking for a company that can get a diagnostics and repairs on the reference controller if necessary. The controller is on a Invacare Panther MX-4, Model No. SC4-89T-CW. The unit has very little time on it but after being left in storage for approximately one year and the batteries completely discharging over the time the unit will no longer operate and we suspect a problem with the controller.Please advise first that you are able to service these units and if so what would be your diagnostic and repair costs.Regards,William Cherrington916-792-7555— Purchase or Repair:

➡️ Reply Penny & Giles

📝 Bob king said:

Get a price testing control box for panther lx4 scooter thanks bob .phone is 304-788-3102 . Cell- 304-790-1334— Purchase or Repair:

➡️ Reply Penny & Giles

📝 Pete Snidal said:

I have a Fortress Scooter with a PnG SOLO controller, with the wiring severely interfered with. Controller has 4 hi-current (ie, #10) wires on one end, and a pair of multi-pin connectors on the other end. One connector has 4 terminals, the other has 10. Controller is mounted in a separate case, with a loom containing Red and Black hi-current wires and a 18 Ga. green wire in it. Also two connectors, one 6-pin, and one 9-pin. My problem is where to connect these conectors and loom on the scooter system. ie, which to motor, to throttle control, from battery pack, etc. Colours from P+G unit to in side of connectors are clear and easily distinguishable. What I need is a wiring diagram, or pin-out from the SOLO to the outside world of the scooter itself. Any help appreciated.ps— Purchase or Repair:

➡️ Reply Penny & Giles