Welcome to Tecaprint

unofficial service & repair forum

We repair a wide range of Tecaprint Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

40+ years of experience repairing Industrial & Commercial units
Certified Senior Industrial Electronics Technician
Ability to do Reverse Engineering
No job to big or small
Fast turn around time on most units
Quality of work comes before profit!
Old Fashion Customer Service is always the right policy
Extended warranty
Fair Estimates
Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

No repair summaries available yet for this manufacturer.

Comments for Tecaprint

1 comments found.

📝 Jeremiah Shem E. Santos said:
Hello There,This is Shem Santos, Mark Process Engineer of Amkor Technology Philippines. Would like to ask for your expert opinion in our quest to improve TPC 261 cure time from 1.5 Hrs to 1 hr. Out current temperature setting is 110 degrees celcius.If ever I opted for 1 hr for faster cycle time do i need to increase the mark cure temperature? Will this have an effect on the solderabitity? Pls advise ASAP.regards,Shem
➡️ Reply Tecaprint

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.