Welcome to Therm-

We repair a wide range of Therm- Equipment.

Ask questions, or 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

🛠️ Common AI Repair Summaries 🏭

Comments for Therm-

📝 Gary Vodvarka said:

I need to know if you still repair these boards. Gary

➡️ Reply Therm-L-Tech

📝 David Borchert said:

I have a Freezer door with a cicuit board of some type in it made by a compnay called Therm - L - Tec. I cannot find any information on this door manufacturer. I think they have gone out of business. We have several places on the circuit board that are bad. Can these be repaired? Please Respond by Email or Call me at 479-445-4130. Thank You,David Borchert

➡️ Reply Therm-L-Tech

📝 Peter Albrecht said:

We used to develop some electronics for Therm L Tech in Kansas City Kansas.If you have any problems please contact us via email at 808 - 227 - 7957Boards which have only relays where not manufactured by us, but we can service them.If you want to contact us via e-mail: thermltech@ihtltd.comP.S. We will be relocating North West Arkansa from Hawaii in about June/July of 2007. The above phone number will change at that time, but the e-mail will remain the same

➡️ Reply Therm-L-Tech

📝 Mike Weber said:

I am looking for a replacement push button in handle of door. Please contact me. I assume I need to drill out rivets on handle to replace button.

➡️ Reply Therm-L-Tech

📝 Steven Cole said:

Peter, I just wanted to say hello, I was the original owner of Therm-L-Tec Systems. Just wanted to let you know that we are in the planning stage of getting back in to business.

➡️ Reply Therm-L-Tech

📝 Mark H. said:

having problem with close limit slipping and also the pull cord works sometimes you can hear the plc humming but nothing happens when you pull the cord need manuals and schematics Thank You Mark H.

➡️ Reply Therm-L-Tech