Welcome to Unimac

unofficial service & repair forum

We repair a wide range of Unimac Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

No repair summaries available yet for this manufacturer.

Comments for Unimac

📝 bharat patel said:

i have a uni mac washer need to repair,not dran porporly

➡️ Reply Unimac

📝 Nizuyir said:

I removed my unimac washer drum for replacement of the bearings in the trunnion.There are two V-rings installed. The outside diameter (OD) is 8.5 inches, and the inside diameter (ID) is 5 inches and thickness is 0.5 inch. I am unable to get the part numbers or suppliers for these items.Could anyone help to identify the parts and also where I can get them.Thank you.Nizuyir Buyong.

➡️ Reply Unimac

📝 BEVERLY Maxwell Newirth said:

I NEED KEY FOR UNIMAC WASHER KEY #3800

➡️ Reply Unimac

📝 Eddie Thomas said:

Where is the nearest service shop located. Need to know the cost for maintenance and repair.

➡️ Reply Unimac

📝 George Park said:

50lb unimac invatar control system.

➡️ Reply Unimac

📝 Viktor said:

Gents, I need P/N for belt for UNIMAC Dryer UB075 E (big one)Thanks

➡️ Reply Unimac

📝 Ramesh Ragha said:

Im looking for a wash motor for UW60P30, slightly used or new, please e-mail me on a price. Thank you.

➡️ Reply Unimac

📝 charles onstead said:

looking for a elect motor for unimac um50p3 washer, unimac p/n 1039266480. voltage 208-240 hz60 wire 4 amps 13 5.5 hp .65kw 530 rpm motor model cp132 c/8-12-2t-4411.please advise price and deliverythanks

➡️ Reply Unimac

📝 JAY PATEL said:

WE NEED A REASONABLY PRICED GOOD USED OR NEW CYLINDER AND TRUNNION ASSEMBLY FOR UNIMAC DRYER MODEL # DTB75CGK ALSO CAN USE INNER AND OUTER TRUNNION BEARINGS FOR SAME MECHINE.

➡️ Reply Unimac

📝 bipin v patel said:

WASHER IS NOTY WORKING,FUSE F21 WAS BAD,WHEN WE CHANGE THE FUSE ITS BLOW OUT AGAIN,DURING THE WASH CYCLE.

➡️ Reply Unimac