Welcome to WES

We repair a wide range of WES Equipment.

Ask questions, or 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Free Estimates
• Low Prices

No repair summaries available yet for this manufacturer.

Comments for WES

📝 niaraki said:

dear sirswe have a colchester/master 600cnc lathe.its control system is crusader ii l anilam microprocesser control system.drive is indramat 3trm2.we bought it as a used mashie. control system dosent work.would you please help us how we can get its troublshooting plan and programming and operating instructions.looking forward to have your prompt answer best regards mr,niaraki— Purchase or Repair:

➡️ Reply Westamp

📝 niaraki said:

dear sirswe have a colchester/master 600cnc lathe.its control system is crusader ii l anilam microprocesser control system.drive is indramat 3trm2.we bought it as a used mashie. control system dosent work.would you please help us how we can get its troublshooting plan and programming and operating instructions.looking forward to have your prompt answer best regards mr,niaraki— Purchase or Repair:

➡️ Reply Westamp

📝 Andres Felipe Marmol Velez said:

Good morming, we are 2 Mechatronic Engineer, we write you becasuse we need a schematic diagram of one of your DC drives in order to retrofit a Bridgeport Mill Machine with Anilam Crusader II panel. Any other information will be gladly recievedThe driver is: Westamp Inc, Assy 30059.We would be very pleased if you can help us.Best regards.Andres— Purchase or Repair:

➡️ Reply Westamp

📝 Harold Godwin said:

I have the same control and am in need of schematic for westamp drive so I can determine whether I have a drive problem or control problem— Purchase or Repair:

➡️ Reply Westamp

📝 miguel rangel said:

I have a milling machine, eqquiped with servocontrol, it has two cards with label WESTAMP 30059-.one of them have some burned components (diodes, resistors)I dont have any information of the circuit cards.can you help me to obtain schematics or send me information about repair service?thanks— Purchase or Repair:

➡️ Reply Westamp

📝 GARY LEBLANC said:

Hello,I am looking for the following circuit/test board:Westamp Inc. Assy 34235 Circuit/Test Board or Assy 34233 Rev. AThank you— Purchase or Repair:

➡️ Reply Westamp

📝 RITA-DU said:

30060-116servometer drive board£¬made by Westamp £¬ 1PCSused for NV10-160— Purchase or Repair:

➡️ Reply Westamp