Welcome to Westamp

We repair a wide range of Westamp Equipment.

Ask questions, or 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Free estimate with an approved repair
• Practical owner-operated pricing
• Purchase orders and Net 7–30 terms for approved business accounts

Send the model and part number with a description of the failure for a repairability review.

Comments for Westamp

📝 Syed Pervez Ali said:

I have one machine vertical mill Avon with crusader II anilam opertating panel.it is not in working position before to run it I want to check it servo drive cards with servo motors , I am 30 years experienced man of working in electronics and industerial equipments.these card are in very good condition, and I am sure they are in working condition. Note:-we have 3 other CNC mill to check up.card detail Westamp INCASSY 30059-some major parts detailout put bridge devices are 29794 TO3 casing mounted on heat sink/base plateIC TL082CP 8 PinIC LM 393 X 2IC LM 1458NIC MM74C08IC UA714Transister2N3019 X 22N2222A2N4856A X2and so onMotor detailServo drive Type MT 30F4-45volts 140rpm 3100cont stall tourque 1.5 NMwith tacho 9.5 volts/1000 RPM insul class FWhat I needBefore sending it for repair I want to make sure that these really need repairing,for that I need its scematic diagram to check it and run it out from the machineif that is not possible atleast its wiring diagram to hook up it with the servomotor and techo generator and give it command signal to run the motor.— Purchase or Repair:

➡️ Reply Westamp

📝 SAUL said:

I NEED THE DIAGRAM OF CONECTION OF THE WESTAMP CARD AW 29947TO TEST THE CARD AND THE SIGNAL IS REQUIRE TO WORKTENKS— Purchase or Repair:

➡️ Reply Westamp

📝 Matt Saponara said:

We have an older Campbell CNC Router which has a westamp drive unit. Westamp Ser. # 756; Mod. # A7214-17F-003(041886). We cant get drive cards anymore and the repaired ones are not lasting. Can we upgrade to a newer drive unit?Matt SaponaraMaintenance ManagerHunter Marine386-462-3658— Purchase or Repair:

➡️ Reply Westamp - Ultradrive