Welcome to Western Graphtec

unofficial service & repair forum

We repair a wide range of Western Graphtec Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

40+ years of experience repairing Industrial & Commercial units
Certified Senior Industrial Electronics Technician
Ability to do Reverse Engineering
No job to big or small
Fast turn around time on most units
Quality of work comes before profit!
Old Fashion Customer Service is always the right policy
Extended warranty
Fair Estimates
Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

No repair summaries available yet for this manufacturer.

Comments for Western Graphtec

1 comments found.

📝 Cherie Disher said:
My plotter got jammed with vinyl. Since then when you turn it on and goes to the left to set itself it gets stuck and I get a Y position error. Can this machine be repaired?Thank you.
➡️ Reply Western Graphtec

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.