Soprel Service & Repair Forum

Hello!, Are from Romania and we have a milling machine equipped with servo drivers pwme 140x14/28 SOPREL type. I would like if possible wiring diagram.We would like very much to get a copy of the wiring diagram for these if you could be of any assistance regarding this we would very much appreciate it.

— Posted by Halmajan Nicolae on 2013-07-17

Reply🗨️Ask a New Question Below❓

If you need your Soprel unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 2 Comments

#Soprel by Paul Young on 2011-11-07 22:54
Hello there, i am from New Zealand and we are retro fitting a Biesse rover 36this has servo drivers that are listed below.SOPREL140X14/28PWME 140X25/50PWME 200X14/28We would like very much to get a copy of the wiring diagram for these if you could be of any assistance regarding this we would very mu...
Show More
➡️ Reply
#Soprel by Halmajan Nicolae on 2013-07-17 06:55
Hello!, Are from Romania and we have a milling machine equipped with servo drivers pwme 140x14/28 SOPREL type. I would like if possible wiring diagram.We would like very much to get a copy of the wiring diagram for these if you could be of any assistance regarding this we would very much appreciate ...
Show More
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.