Therm-L-Tech Service & Repair Forum

We used to develop some electronics for Therm L Tech in Kansas City Kansas.If you have any problems please contact us via email at 808 - 227 - 7957Boards which have only relays where not manufactured by us, but we can service them.If you want to contact us via e-mail: thermltech@ihtltd.comP.S. We will be relocating North West Arkansa from Hawaii in about June/July of 2007. The above phone number will change at that time, but the e-mail will remain the same

— Posted by Peter Albrecht on 2007-05-02

Reply🗨️Ask a New Question Below❓

If you need your Therm-L-Tech unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 6 Comments

#Therm-L-Tech by Gary Vodvarka on 2006-04-11 18:35
I need to know if you still repair these boards. Gary
➡️ Reply
#Therm-L-Tech by David Borchert on 2006-08-25 15:18
I have a Freezer door with a cicuit board of some type in it made by a compnay called Therm - L - Tec. I cannot find any information on this door manufacturer. I think they have gone out of business. We have several places on the circuit board that are bad. Can these be repaired? Please Respond by E...
Show More
➡️ Reply
#Therm-L-Tech by Peter Albrecht on 2007-05-02 22:25
We used to develop some electronics for Therm L Tech in Kansas City Kansas.If you have any problems please contact us via email at 808 - 227 - 7957Boards which have only relays where not manufactured by us, but we can service them.If you want to contact us via e-mail: thermltech@ihtltd.comP.S. We wi...
Show More
➡️ Reply
#Therm-L-Tech by Mark H. on 2007-08-07 16:13
having problem with close limit slipping and also the pull cord works sometimes you can hear the plc humming but nothing happens when you pull the cord need manuals and schematics Thank You Mark H.
➡️ Reply
#Therm-L-Tech by Mike Weber on 2011-03-25 17:58
I am looking for a replacement push button in handle of door. Please contact me. I assume I need to drill out rivets on handle to replace button.
➡️ Reply
#Therm-L-Tech by Steven Cole on 2011-05-15 12:55
Peter, I just wanted to say hello, I was the original owner of Therm-L-Tec Systems. Just wanted to let you know that we are in the planning stage of getting back in to business.
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.