K.E.W Service & Repair Forum

Looking for parts manual of help with parts for Unit Model #3803V-103 1985/40No.# 2104067 240v/1/30 ampAny help would be greatly appreciated.

— Posted by Kevin Gonneau on 2007-05-07

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "K.E.W"

If you need your K.E.W unit tested or repaired,
give us a call at 1-336-969-0110.
We offer free estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 95 Comments

#K.E.W by ali on 2009-05-31 05:45
I\'m looking for the maintenance manual for this machine
➡️ Reply
#K.E.W by Tim on 2009-09-28 17:42
I am looking for a seal kit for the pump on this unit if you can get one please email me back.
➡️ Reply
#K.E.W by cindy janeski on 2009-05-28 18:35
I am looking for a shop that carries replacement parts for a KEW pressure washer, the hose has sprung a leak and need to replace it the spray nozzle is also attached to the hose as a all in one unit
➡️ Reply
#K.E.W by Bob Schultz III on 2011-08-17 15:47
I need a service manual with part numbers and specifacation please.
➡️ Reply
#K.E.W by Richard Lane on 2008-12-24 11:32
HelloI have a kew 1502 steam cleaner which has a problem with the burner. It will run for about 5 seconds then cut out, I have changed the diesel filter and cleaned the filter into the nozzle. Also I have checked that the electrodes are working properly. Its as if something is turning the diesel sup…...
Show More
➡️ Reply
#K.E.W by William Knee on 2009-03-21 12:25
HI I check all and no start and I am a Electrician
➡️ Reply
#K.E.W by mark on 2008-07-06 07:56
clean out the disel jet, clean out fillter under the fan, make sure u have good tight flexi hose connection, good luck
➡️ Reply
#K.E.W by TOBY ANDERSON on 2014-08-15 17:47
I have a kew alto 2340ha Everything was working and the usint up and quit It showed a 0 flashing and I unplougged it and put it back it reset to solid 0 but when you push the power on it does nothing. I let sit unplugged but nothing works now. Is there anyone who works on these anymore I am in Wisco…...
Show More
➡️ Reply
#K.E.W by Blair on 2007-08-15 01:10
call windy city equipment located in Elgin, Illinois
➡️ Reply
#K.E.W by Ron on 2010-10-12 02:52
My coil froze last winer when heater broke in shop over weekend , do you have any coils
➡️ Reply
#K.E.W by Hartono on 2011-10-19 06:46
Dear AllPlease give me the information about Services center KEW 0901V In indonesia , for your best cooperation i would to say many thanks
➡️ Reply
#K.E.W by mark on 2014-10-21 13:50
hi could you tell me where I would get service manual for kew 1640hathanks mark
➡️ Reply
#K.E.W by Serge on 2013-06-13 13:06
HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks!
➡️ Reply
#K.E.W by john farkas on 2011-10-26 18:38
I am looking a the circuit board for my 0840HA hot water pressure washer. Mine burned out, the rest of the machine is nearly new. It would be a shame to trash it. KEW no longer makes this board.
➡️ Reply
#K.E.W by shaban limani on 2011-07-02 17:12
JA ICSH BIN LIMANI CSHABAN ICSH BRAUCHE EINE PUMP MACSHINE FOR AUTO VACSH MACSHINE IST FOR MARKE K.E.W 1502V ICSH CHAP MACSHINE ABER PUMP IST KAPUT BITEIN MAINE EMAIL CSHIKENSI DI VORT FOR MAINE RESPEKT
➡️ Reply
#K.E.W by KEIRON on 2008-04-03 18:18
my steam cleaner is flashing F1 light, does anyone know what this fault is and does anyone have a manuel for this model?many thanks
➡️ Reply
#K.E.W by holmeside garage lee scott on 2012-02-13 22:01
i have a kew 1640ha which i am having a bit trouble with reacently when whent to use it it cum up with the fault L1 and now the machine will not start,i was wundering if you could give me a bit help THANKS
➡️ Reply
#K.E.W by swordcrown sevices on 2008-08-02 22:17
we have a KEW steam cleaner,not sure of age,trolley mounted, recent purchase, but not working.is there anybody out there who can help us, with regards to diagrams, or any possible imformation, perhaps we can then decide on further age, model etc , your help would be greatly appreciated.Yours sincere…...
Show More
➡️ Reply
#K.E.W by Rudy Martens on 2009-10-28 06:19
I need a operation manual for KEW 1502v-66
➡️ Reply
#K.E.W by Hassan Mortazavi on 2010-10-08 16:23
i just got a used ke w scorpian steam cleaner and everything works exept it does not ignite or no spark to get flame.any idea.thankshassan
➡️ Reply
#K.E.W by Tom Duclos on 2016-05-31 14:22
Need transformer for above unit part number #3819901 can you help me..
➡️ Reply
#K.E.W by Six B Construction on 2008-10-02 15:28
I need a operation manuel for K.E.W. 3803V-103
➡️ Reply
#K.E.W by Gerald Mansfield on 2007-10-01 00:46
I purchased a K.E.W. 1500 unit on a sale and would like to get an owners manual/service manual for it. It\'s an electric unit. Thank you, Gerry Mansfield
➡️ Reply
#K.E.W by sandy stevens on 2009-09-28 13:03
Is there anyway to get a takedown of the pump on my kew steam cleaner the model # 08022-56? A parts book would be good.
➡️ Reply
#K.E.W by EdwardKn on 2015-03-27 17:20
Hello. And Bye.
➡️ Reply
#K.E.W by lyndon hammill on 2006-11-06 19:24
All the lights on the temp gauge lit means that the fuel tankis empty. If there is fuel in the tank, there may not be enoughto activate the tank sensor. put more fuel in.If the tank is full,the tank sender is faulty. It will need replacing.In the meentime you can bypass the tank sender by shorting o…...
Show More
➡️ Reply
#K.E.W by LIMANI on 2010-08-08 21:44
guten abent icsh bin limani cshaban aus macedonia icsh brauche eine tail for meine macshine das chaist pumpe for k.e.w.1502 iat mit drei klipen un federen und kenzi zaigen prais bite
➡️ Reply
#K.E.W by Stuart on 2008-08-09 08:20
I need a service manual for a KEW 1502-66 with exploded views, parts lists with prices... thank you for your time and help with this problem..
➡️ Reply
#K.E.W by dan johnson on 2007-05-28 23:54
I am trying to find out any info on this Kew (0802v-56)steam washer. If someone has a manual available, that would be great.
➡️ Reply
#K.E.W by gary case on 2010-09-23 15:00
we can\'t get water flow through the machine
➡️ Reply
#K.E.W by Ruth Montefiore on 2010-03-15 13:33
The black hose pipe connected to this pressure washer has a whole in it. Can it be repaired and if so how please. If not how much will it cost to desptach a replacement to me or where can I purchase this hose pipe? Is it something I can obtain from a builders merchants and if so what size please?I l…...
Show More
➡️ Reply
#K.E.W by Jeff Osborn on 2009-11-23 21:46
I have recently acquired a K.E.W. Pressure washer and am trying to find information about it. It appears to be from Denmark and in the Model box it just says Hobby. Another box on the ID plate says 62 bar. The gauge on the machine reads 0 to 150 and on the face of the dial it says X 1000. THAT WOULD…...
Show More
➡️ Reply
#K.E.W by Dale on 2009-04-08 00:10
Hi, put a oring kit in pump an still get only tap pressure everything looks good ,keyway on pump motor fine. any ideas. Thanks,
➡️ Reply
#K.E.W by Tom Hamilton on 2009-12-16 22:16
I may have the same pressure washer you have. My pressure gauge shows two circular pressure scales. The outer scale is from 0 to 150 with a heavy mark at the 50 digit and 100 digit. At the bottom it says \"BAR\". If your information plate says 62 BAR as mine does then acceptable pressure is between …...
Show More
➡️ Reply
#K.E.W by m j cars on 2011-03-17 11:08
when i turn the machine on it trips the electrick
➡️ Reply
#K.E.W by JAMES FARMER on 2016-05-02 19:22
the fuel will not pump, I don`t have the voltage coming out of the oil area of the board to open the solenoid on the fuel pump. I need a schematic to trace the problem, is there one available ?
➡️ Reply
#K.E.W by reidar kvalvik on 2010-04-19 13:53
Hi.I need reper manual for KEW royalBest regards Reidar Kvalvik
➡️ Reply
#K.E.W by Jesus on 2019-10-11 08:59
Hi I have a KEW 1502v and some body stolen parts so I put all back together but for any reason it not working the heater and I suspected it about the wiring position, and the pressure is stopping and not keep spraying and some times work fine but some times not, one time I fix only with a new clamp …...
Show More
➡️ Reply
#K.E.W by mario yasin on 2012-12-04 21:44
i need to fix my pei kew 4503kb pumbe kit and throtecan you fix itthank you
➡️ Reply
#K.E.W by Josh Campbell on 2005-10-26 14:14
I am trying to refurbish a kew 1502v-66 power washer. I cannot get the oil fired burner to kick on. The control panel has a digital temp gauge and it shows the temperature of the water at its maximum value when the water is cold. I am in question if this is the problem with the burner not firing. I …...
Show More
➡️ Reply
#K.E.W by AUSTIN GIBBONS on 2010-03-30 14:40
CAN I BUY A SPARE PART FOR THE ABOVE, IE, THE PRESSURE WASHER AT THE END OF THE LANCE.?WITH THANKS AUSTIN GIBBONS
➡️ Reply
#K.E.W by Raymond Cooper on 2007-12-19 04:18
I need a service manual for a KEW 4503KB with exploded views, parts lists with prices... thank you for your time and help with this problem..Raymond Cooper951-926-5394
➡️ Reply
#K.E.W by Richard Beck on 2009-05-25 21:04
Have a Kew 3803V pressure washer, need to know where I can get itrepaired nearby.thank you
➡️ Reply
#K.E.W by Odyssey Winery on 2010-08-23 21:14
I have a KEW pressure washer, model 0840HA. I am receiving intermittant F2 error codes and C4 error codes. I have taken it into my dealer for \"repair\" however the problem continues. Any ideas?
➡️ Reply
#K.E.W by ken williams on 2011-11-08 03:02
Hi would you have a service manual for this cleaner??
➡️ Reply
#K.E.W by marcondes on 2010-03-17 22:11
my machine stop work hot water and pressure no good work
➡️ Reply
#K.E.W by Joe Duran on 2008-06-13 23:41
Can I find a manual ?I was given one of these to me by a customer. I think I need a special water hose??
➡️ Reply
#K.E.W by PAUL GALLAGHER on 2008-11-17 21:50
HI,I HAVE JUST PURCHASED A KEW 38A2VA POWER WASHER. IS IT POSSIBLE TO GET A MANUAL FOR THIS MACHINE? ALSO WHAT GOES IN THE TANK MARKED WITH A SNOWFLAKE?THANKS PAUL.
➡️ Reply
#K.E.W by Len on 2009-10-23 14:28
I have a copy of the users instruction book for this machine if you are still in need.
➡️ Reply
#K.E.W by steve oliveros on 2011-06-24 22:12
i need a parts list so i could repair the pump
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.