Atlas Copco Service & Repair Forum

kindly send as soon as possible

—> Purchase or Repair: Ticket Image

— Posted by bhaskar on 2009-07-30

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "Atlas Copco"

If you need your Atlas Copco unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110


Recent 1316 Comments

#Atlas Copco by Pandaya on 2009-03-29 07:14
Dear sirwe need operating instruction for air compresor atlas copco GA75type 1900-0581-05LD4 (Display using seven segmen)Thank you very muchregardpandaya

—> Purchase or Repair:
#Atlas Copco by Gianni on 2008-02-22 13:45
Very likely send temperature sensor failure

—> Purchase or Repair:
#Atlas Copco by cesar on 2010-02-11 23:01
do you guys have a operators manual for a atlos copco dryer model.fd380 type r404a i bought one at an auction with no manual

—> Purchase or Repair:
#Atlas Copco by Rakesh K Sharma on 2011-04-10 05:23
I have two units Screw Compressor Atlas copco GA 22 & one GA 45There is problem in the electrical.I need an wiring electrical for compressor Atlas Copco GA 22,And elektronikon 1 controller manual.please send me to wiring electrical & manualBest Regards,Rakesh SharmaIndag rubber.ltdNalagarh,SolanHima…Purchase or Repair: Ticket Image...
Show More
#Atlas Copco by Victor on 2010-02-17 07:07
Dear sir ,need Elektronikon I panel manual.We are use Your product (air compressor) With best regardsVictor

—> Purchase or Repair:
#Atlas Copco by azadeh on 2009-04-20 11:37
plise sent to me catalog for circuit of electronikion to my email.tanks for you .

—> Purchase or Repair:
#Atlas Copco by Mohsin ali on 2021-04-22 09:57
Atas copco elecktronikon display fault 100300000000

—> Purchase or Repair:
#Atlas Copco by Richard Nichols on 2009-08-06 20:48
The above module was recently replaced due to display and inputs \"freezing up\" and not functioning. The new module works fine. Can the malfunctioning module be rebuilt and tested? Perhaps the K4 relay, which sees a lot of action could also be replaced? How much cost? It was running on a 2004 ZT55 …Purchase or Repair: Ticket Image...
Show More
#Atlas Copco by mohamed kandil on 2011-10-24 08:16
i have ZR-250 compressori have worning condensate drain RC out not ok and zr-160 compressorelement frist tempr maximum 227 cmax = 225

—> Purchase or Repair:
#Atlas Copco by Rico on 2011-05-10 03:39
Dear Alats Copco!If you have GA 200 Compressor User manual, please send me for my study. Thanks a lots

—> Purchase or Repair:
#Atlas Copco by ashwin sami on 2008-04-30 23:41
GA 18 P COMPRESSOR SERIAL NO. 000058128Need the both tranformer part number to replaces with faulty one

—> Purchase or Repair:
#Atlas Copco by srinivas on 2011-02-28 06:31
Dear sir,Please help me out of this issue i am unable to trace the problem send the manual GA 55+thanks & regards,J Srinivas jammulasrinivass@gmail.com9440867602

—> Purchase or Repair:
#Atlas Copco by Atul Kanakdande on 2011-01-06 04:38
I need Electronikon controller user manual

—> Purchase or Repair:
#Atlas Copco by daniel davila on 2012-10-11 20:16
Ineed to know how keep the separator temp below 210ºF,I cleaned the combicooler, room\'s temp it\'s 80ºF,oil level it\'s OK, whatelse can I do?thank\'s in advance for your support.

—> Purchase or Repair:
#Atlas Copco by Tejas on 2011-07-13 02:02
I am facinga problem since last many days about wiring details in my instrument laboratory.So,please arrange to send me a complete manual for our maintenance purose of view.

—> Purchase or Repair:
#Atlas Copco by milenko markotic on 2011-03-17 18:49
PLEASE IS IT POSSIBLE TO GET WIRING DIAGRAM FOR THIS KOMPRESOR

—> Purchase or Repair:
#Atlas Copco by Babur on 2010-03-13 20:13
Hello, I am interested in the Atlas Copco Elektronikon 1900070124 controller for purchase. Could you please provide information on pricing and availability? I am looking to source this product quickly. Thank you.

—> Purchase or Repair:
#Atlas Copco by mourad on 2016-09-13 09:40
J\'ai deux compresseur atlas copco GA 75 FF + ET j\'ai besoin du schéma electrique pour COMPRESSEUR GA 75 FF+

—> Purchase or Repair:
#Atlas Copco by Euler Resende on 2011-12-21 04:25
Please provide the details of the Atlas Copco Elektronikon II 1900 0710 12 controller so we can check if it is still supported or if replacement parts are available. Thank you.

—> Purchase or Repair:
#Atlas Copco by Mukul Mishra on 2010-04-07 03:26
We are facing problem with electronicon controller used in our Atlas Copco Compressor.In three number of controllers some DI or DO channel has become faulty. Please suggest is it possible to configure some another spare channel with the help of controller programming.Thanks

—> Purchase or Repair:
#Atlas Copco by Mario Machado on 2008-06-02 21:56
Dear Sr.I Need ELECTRONIKON technical Manual..P/N: 1900 0700 08 ed: 01serial: 02024700083Mário

—> Purchase or Repair:
#Atlas Copco by Cao Ngọc Hà on 2010-04-12 04:47
Dear Sirs,I\'m from Vinaconex Advanced Compound Stone JSC in Viet Nam, I\'d like to order the VSD Controller for our Atlas Copco Compressor GA 30FF.Can you supply it?Best regars,Cao Ngoc Ha

—> Purchase or Repair:
#Atlas Copco by Kundzins on 2010-11-03 19:42
Electronikon 1900059812 controller not responding or displaying any information.

—> Purchase or Repair:
#Atlas Copco by MAHMOUD ODEH on 2008-07-01 11:12
manual for elektronikon I (new generation )

—> Purchase or Repair:
#Atlas Copco by msureshchander on 2010-10-14 06:13
good efficiency compressor

—> Purchase or Repair:
#Atlas Copco by Fan on 2011-05-12 09:14
AIR COMPRESOR

—> Purchase or Repair:
#Atlas Copco by Ron Ledwell on 2008-03-18 19:52
The unit that typically manages the air compressor's operation and monitoring system is showing abnormal behavior. It is not displaying the usual readings or responding as it normally would.

—> Purchase or Repair:
#Atlas Copco by virginia on 2011-06-15 07:28
Necesitaria el manual de usuario de un compresor GA 75

—> Purchase or Repair:
#Atlas Copco by ydrebla on 2009-10-12 23:53
please I need to check something in this manual

—> Purchase or Repair:
#Atlas Copco by ramawat on 2012-09-21 16:47
The Elecktronikon 1900-0590-12 controller on the production line is malfunctioning, causing delays and affecting our output. We need immediate assistance to resolve this issue and get the production line back up and running efficiently.

—> Purchase or Repair:
#Atlas Copco by Kevin Nosowicz on 2014-12-19 19:44
Elektronikon II 1900071011 control/display module just went kaput. Need a replacement ASAP. Heading to the next machine now.

—> Purchase or Repair:
#Atlas Copco by Todd Ruesch on 2010-03-22 01:59
Hi there, we have an issue with our Atlas Copco Elektronikon 1900070124 controller and need a replacement. Could you please provide repair information or let us know where we can find a replacement quickly? Thank you!

—> Purchase or Repair:
#Atlas Copco by James Brown on 2008-10-13 08:00
The Atlas Copco 1900 0701 02 experienced downtime due to an issue with the Elektronikon unit today during the morning shift. Can you provide insight into what caused the problem so we can address it before the next shift?

—> Purchase or Repair:
#Atlas Copco by N.GOPISANKAR on 2011-09-29 09:18
GA 30 VSD MODEL ATLAS CAPCO COMPRESSOR ELEKTRONIKAN 2 DISPLAY SOS\" COMPRESSOR MOTOR CONVERT TIME OUT\"

—> Purchase or Repair:
#Atlas Copco by Mark Bateman on 2009-12-29 05:45
need a user manual or someone to contact me on 0407000457 to get our compressor going again, won\'t start after a blackout

—> Purchase or Repair:
#Atlas Copco by Patrice LESPINE on 2012-10-22 09:32
Bonjour,Pourrai je avoir le schéma electrique des connecteurs de l\'elektronikon1pour un GA15 AII282414.Merci.Patrice LESPINE

—> Purchase or Repair:
#Atlas Copco by Atiq Khan on 2010-08-31 11:10
we lost our manual. please help us

—> Purchase or Repair:
#Atlas Copco by kousar pasha on 2014-09-27 17:45
Atlsas copco compressor is a number 1 compressor maintanence proper give more life

—> Purchase or Repair:
#Atlas Copco by salah on 2011-04-01 08:13
plz is the following item available till nowelektronikon p/n:1900 0700 08 s.n:0201150007924vac/18va

—> Purchase or Repair:
#Atlas Copco by sean o connor on 2009-06-12 08:06
have compresser serial no aii351702 kneed to change settingshope yoy can help thanks sean

—> Purchase or Repair:
#Atlas Copco by BALDO MEDINA on 2020-01-03 16:29
I receive a error code 110300000000 on my atlas compressor GA180VSD

—> Purchase or Repair:
#Atlas Copco by Adison on 2016-12-02 08:00
I have an error that said to me "compressor element 116 grad celsius".I should to know what is this?

—> Purchase or Repair:
#Atlas Copco by aslam hassan vk on 2015-04-13 07:01
good performance

—> Purchase or Repair:
#Atlas Copco by paimblanc on 2013-05-08 06:27
The controller on my Atlas Copco GA45 1900.0590.74 industrial unit is not functioning properly and needs repair. Looking for assistance to get it back up and running efficiently as soon as possible. Thank you.

—> Purchase or Repair:
#Atlas Copco by Haseeb on 2012-12-24 06:14
Dear SirI need Atlas Copco GA55 Plus electrical power and control manual pleas send meThanking YouHaseeb

—> Purchase or Repair:
#Atlas Copco by Behcet on 2009-11-18 07:49
I need from electronikon software and some technical manual.Thanks for your help.

—> Purchase or Repair:
#Atlas Copco by Riemann on 2013-07-17 15:44
Hey there, we are in urgent need of repair info for the Atlas Copco Elektronikon 1900 0701 05 controller. It stopped working and we need a replacement. Can you please provide some guidance or let us know where we can source a replacement quickly? Thank you.

—> Purchase or Repair:
#Atlas Copco by TOMMY LIKUBO on 2008-01-15 14:35
The Atlas Copco 1900 0701 02 unit with Elektronikon is not working. Maintenance team needs assistance.

—> Purchase or Repair:
#Atlas Copco by saad on 2008-03-20 07:51
the Atlas Copco 1900 0701 02 Elektronikon unit went down mid-shift. Please follow up tomorrow.

—> Purchase or Repair:
#Atlas Copco by Hoa Hoang on 2010-11-11 09:16
We have two Atlas Copco GA37Plus co-oper, change to other apter 20hours, but apter maintain only 01 compress. operation and 01 standby and its can\'t change.Please sent me documents detail for this system, machine no. API508418/508419

—> Purchase or Repair:

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.