American Farmworks for Service call 1-336-969-0110 at Industrial Electronics Repair

American Farmworks Service & Repair Forum

One of the Printed Circuit boards has a failed spot (burned) at a transistor connection. Is this circuit board available for replacement. If available estimated cost?Info: Model 0122-92 ART Rev-2 PCB (2360023.003) CP4ThanksLynn Reifschneider

— Posted by Lynn Reifschneider on 2008-08-17

Reply🗨️Ask a New Question Below❓

If you need your American Farmworks unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 48 Comments

#American Farmworks by Craig W. Floyd on 2006-05-08 01:04

My AFW 901, S/N 000929000445, manufactured in 2000 has stopped working. When I open it, there are no obvious \"blown\" parts. Is this unit worth sending in for repair? What might the cost be, including shipping both ways?Thank you.Craig Floyd

#American Farmworks by Scott Urban on 2007-09-03 21:29

Can you tell me how many miles of fence the Bull Dozer WD 56, model #: WD 56-b will charge? How do I know if it works?

#American Farmworks by Tom on 2008-04-18 01:17

Hello, I am working on an International Super 5000. It has 3 electronic boards in it marked American Farmworks model #\'s; 01447-92; 01448-92; 01479-92. I am trying to locate a schematic for these and/or any repair info/testing procedures for these. Thank you, Tom

#American Farmworks by Lynn Reifschneider on 2008-08-17 18:49

One of the Printed Circuit boards has a failed spot (burned) at a transistor connection. Is this circuit board available for replacement. If available estimated cost?Info: Model 0122-92 ART Rev-2 PCB (2360023.003) CP4ThanksLynn Reifschneider

#American Farmworks by Kelly Boyd on 2008-09-10 01:16

Tom: Did you ever locate any information on this board - we are needing to repair or replace the board - any luck?

#American Farmworks by john ivers on 2009-05-18 19:59

Can I get a print of the circuit bds. for model A50LIL sn #0605260066

#American Farmworks by Stanley P Watkins Jr on 2009-06-22 02:39

Stopped working . doubt lightning as it was near the house. Please send estimate and instructions.Stanley Watkins

#American Farmworks by Floyd Maguire on 2009-07-09 17:47

I have a Sun Scorpion Electric Fence Charger that does not work. I cannot get inside to see if the battery has gone dead. How much would you charge to service the unit?

#American Farmworks by Linda Greene on 2009-07-30 17:35

We need the replacement box for Model 01479-92 for an electric fence box . The number on the board is W447. Please let us know what the replacement cost will be.Thank You

#American Farmworks by RONALD OGLETREE on 2010-02-18 19:56

CAN YOU GIVE ME INY INFORMATION ABOUT FENCE CHARGER A50LIL

#American Farmworks by GEORGE SUTTON on 2010-04-17 16:40

I have an International electric fence controller Model# S-12-A that needs repair. Please advise where it can be sent to bring it to a usable condition. Thank You

#American Farmworks by Jim on 2010-04-30 03:37

I have a 5000 that was in a barn on a farm that we bought. It is missing the power cord and the circuit board. In my opinion, these are great chargers and I would like to find parts to repair it. I can\'t find any International info, but have been to the Zareba sight and it appears that the A100LI Z...
Show More

#American Farmworks by john conway fencer repair on 2010-05-07 23:55

tom i am working the same type model you are now . using a paper chart wont help you a lot because the three boards would need to be tested by each one alone, the largest board called the mother board is most popular to go first ,then the long horizonal board is next the small vertical last if you w...
Show More

#American Farmworks by william edwards on 2010-08-15 19:41

I need an installation and operating instruction manual. Can this model be powered by a transformer and rectifier ?

#American Farmworks by Roy Frazier on 2010-09-28 13:37

What is your mailing address

#American Farmworks by Roy Frazier on 2010-09-28 13:42

Needs to be repaired. Would like address to send. Thanks

#American Farmworks by vito on 2010-12-04 18:46

Hello,Can you send me the schematic for a fence charger Model WASP -1 01479-92. Also, the problem that i am experiencing is the box does not make a clicking sound. There is no output from the charge. Thank you for your time. Vito

#American Farmworks by Karen Carroll on 2010-12-04 21:39

My horses pulled the AC plug out of my Bulldozer fencer. I see which 2 spade prongs the plug came off of, but I don\'t know which is the black wire and which is the white wire. The prongs are labeled J1 and J2 on a model 01447-92 board. Can you assist me with this?

#American Farmworks by john petersen on 2011-03-22 03:54

I have an American Farmworks Model 50 B charger with 3 electronic boards and the same numbers you described above. There is something not right with charger and I think (not sure) it is in the transformer circuit. I am trying to get a wiring diagram or schematic so I can troubleshoot.

#American Farmworks by David Murphy on 2011-03-27 17:44

The curcuit board shorted out under the W621 board. I would like to order a new board to replace this curcuit board. I need the model 01447-92 and all componnets that go with this board. Please let me know if I am able to get these parts.Thanks David Murphy218-390-2655 cell715-398-7106 home

#American Farmworks by Kay Lacy on 2011-10-31 20:09

I have a 50-B electric fence charger that is not working. Do you think it would be good to try to repair or just purchase a new one. We have had real good luck with these fencers and still have one is use so hate to just throw away.

#American Farmworks by James D. Ayres on 2011-11-01 23:57

INEED TO REPLACE A MODEL:0123-92 TRANSFORMER BOARD. iT IS ARCING. DO YOU HAVE ONE?

#American Farmworks by joseph luth on 2012-01-25 00:29

need the above part for a hol dem model 57 fence box part number 07054-92 home phone 1-951-302-6801 thanks

#American Farmworks by sue on 2012-04-04 15:03

i was wondering if this is your product and if its safe to use model #mt090980206601

#American Farmworks by Cliff Bang on 2012-04-17 20:02

HOL-DEM Model 50Low impedance 6 joule energy outputFencer is clicking but fence ok light is not working. And am getting no shock out of it. What could be wrong and what would the cost be to repair?

#American Farmworks by Gary Shirey on 2012-05-21 17:34

Can I run this charger on a 6 volt battery charger without damage to it ? Thank you

#American Farmworks by Dan Smith on 2012-06-26 18:34

I have an old Bulldozer 4000 A, ser#55903-6117 that I have grown attached to and would like to repair, Bought a new battery in 2007 and I tested it and it is still good. I would like to troubleshoot other components , and repair if possible.

#American Farmworks by luis fernando barrera ledesma on 2012-11-12 14:01

Buen día srs de Farm Works, tengo a mi haber un impulsor de cerca eléctrica Sun Scorpion VSS-1, que sufrió una descarga eléctrica y se quemaron varios de los componentes electrónicos , como integrados , SCRs y transistores y quiero repararlo, por lo tanto , si es posible el suministro del diagrama e...
Show More

#American Farmworks by Don Miller on 2013-03-06 20:44

bulldozer 4465dcost to repair encluding H& P Don

#American Farmworks by Darren Coffey on 2013-04-19 23:03

I would like a price on the American Farmworks model# 01479-92 transformer for a fence charger I would like 3 of these shipped to the 47330 zip code if you could email me with a price.

#American Farmworks by Joseph Cecil on 2013-05-07 00:33

Do you Sale this board or parts for it. I need three diodes S727 S8055M?

#American Farmworks by Joe Lagano on 2013-05-22 00:37

I am trying to find out how many feet this will supply electric to. I am using it for horses. If you need to talk to me I can be reached after 2 PM est at 302-245-4236

#American Farmworks by john callender on 2015-02-06 16:52

I have a zareba fence charger, 200 mile. it has the American farmworks model 01479-92 transformer boards in them, one bad for sure and the other is questionable. do you carry these and are they available and the price. Thank you John Callender F&R Farms.

#American Farmworks by Jim Edwards on 2015-03-24 20:44

Need a price for a Farmworks 01479-92 Transformer PCB. This came out of a electric fence charger that was hit by lighting.

#American Farmworks by David Bare on 2015-07-09 19:06

Need to get this fencer looked at to be fixed. is there anyone close to my location who works on them?

#American Farmworks by Mark Parrish on 2015-10-03 02:04

Do you all still carry this board (American Farmworks 01479-92)? I would like one.Thanks,Mark

#American Farmworks by Dan Santee on 2017-01-13 20:34

I have 2 American frameworks model 1479-92 transformer boards that the primary winding on Transformer is open. Can I buy just the transformers from you and put them in myself? If yes ,how much for the 2 transformers? If no ,where can I buy them?

#American Farmworks by Don Pritchard on 2017-03-29 18:49

I'm looking to purchase the transformer for a Model 01479-92. What is the price? Thank you!

#American Farmworks by Randy Dahl on 2017-04-20 18:04

I'm also looking to purchase the 01479-92 Transformer Board. Could I get a part# of the transformer? please email back, thanks

#American Farmworks by Ualberto Vazquez on 2017-07-21 03:50

The generator of electric pulses does not turn on so I want to crack the electric circuit and crack because it does not turn on. I occupy a copy of the tdod plane the circuit for the model 01447-92 and 01479-92. I expect comments.

#American Farmworks by Gary on 2017-11-09 16:24

Do you all still carry this board (American Farmworks 01479-92)? I would like one.

#American Farmworks by Dennis Ingalls on 2018-03-03 02:24

Purchased older fence charger, Bulldozer 4612. Is there any information still available for this unit. Do you need additional information to process this request.I have found this unit to be very dependable, however lately it started functioning erratically. I know it would be cheaper to buy another...
Show More

#American Farmworks by Dave Borgfield on 2018-09-05 11:47

need a price on part# 01479-92

#American Farmworks by LelandpuS on 2019-08-23 00:00

Got a failed drive or board on the American Farmworks 01447-92 circuit board. Need to troubleshoot and replace it ASAP to keep everything running smoothly.

#American Farmworks by Ward Malcolm on 2021-02-01 21:58

i have a 100 mile zareba fencer that does not work now. i need the transformer board and an SCR, according to my testing. thanks

#American Farmworks by Gene Peters on 2021-06-09 03:06

I need a part 01479-92. The one I have has a open primary winding.I also need the price of a new one.Thank YouGene

#American Farmworks by Steven Anderson on 2021-09-13 20:30

Do you still carry this board(American Farmworks 01479-92)?

#American Farmworks by Richard Feutz on 2024-11-03 03:23

do you sell American Farmworks 01479-92 board or the transformer on it?Please let me know cost and availability

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.