Atlas Copco Service & Repair Forum

tengo falla no 13 en elektronikon

—> Purchase or Repair: Ticket Image

— Posted by jacqueline alvarez on 2010-01-26

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "Atlas Copco"

If you need your Atlas Copco unit tested or repaired,
give us a call at 1-336-969-0110.
We offer free estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110


Recent 1316 Comments

#Atlas Copco by cesar on 2010-02-11 23:01
do you guys have a operators manual for a atlos copco dryer model.fd380 type r404a i bought one at an auction with no manual

—> Purchase or Repair:
#Atlas Copco by yahya asy on 2009-12-08 07:40
hi pls..i need service manual for elektronikon controllerthank you

—> Purchase or Repair:
#Atlas Copco by Richard Nichols on 2009-08-06 20:48
The above module was recently replaced due to display and inputs \"freezing up\" and not functioning. The new module works fine. Can the malfunctioning module be rebuilt and tested? Perhaps the K4 relay, which sees a lot of action could also be replaced? How much cost? It was running on a 2004 ZT55 …Purchase or Repair: Ticket Image...
Show More
#Atlas Copco by Juan Luis Llado on 2009-12-10 18:49
hi,I need a trouble shooting manual for a Atlas Copco Mod. GA 209

—> Purchase or Repair:
#Atlas Copco by Victor on 2013-06-03 10:27
Hi, try to find and fix the parameters for communications on converter, it must be set the same baudrate as Elektronicon (19600).

—> Purchase or Repair:
#Atlas Copco by nagarajan.g on 2009-03-20 10:35
schematic diagram of ga30

—> Purchase or Repair:
#Atlas Copco by sivakumar on 2009-12-13 10:26
Dear sir, I am sivakumar working in Arabian bulk terminal (ETA Group),sudan.Here one problem in electronikon 1 panel did not reset.Please replay service center near country then how brought new one address. ThanksBest regardsS.SivakumarE&I Dept.Sudan.

—> Purchase or Repair:
#Atlas Copco by Muhammad Shafiq on 2017-05-23 16:11
Hi we are looking for Elektronikon 1900 0700 07 electrical connection diagram

—> Purchase or Repair:
#Atlas Copco by DEBASISH GOUDA on 2009-09-15 10:00
Electronikon controller is a very good controller.

—> Purchase or Repair:
#Atlas Copco by jacqueline alvarez on 2010-01-26 19:32
tengo falla no 13 en elektronikon

—> Purchase or Repair:
#Atlas Copco by Ghislain Gagnon on 2010-03-06 18:01
J\'ai besoin de connaitre les contacts auxiliaires du compresseur pour qu\'il démare un ventillateur quand il démare.

—> Purchase or Repair:
#Atlas Copco by MUHIRWA Prosper on 2009-10-24 08:28
I NEED MANUEL FOR ATLAS COPCO GA55AFFTHANKS.

—> Purchase or Repair:
#Atlas Copco by manazir on 2009-12-03 06:09
a soon as posible

—> Purchase or Repair:
#Atlas Copco by chris on 2016-04-15 13:29
Hiwould it be possible if i could recieve wiring diagram for plc thanks.modell no. GA22PART no. 1900071103serial no. 01110502342

—> Purchase or Repair:
#Atlas Copco by Skeeter Porter on 2013-03-21 13:40
Hello, we are in urgent need of repair information for an Atlas Copco Elektronikon 1900070008 control panel for a screw compressor. Could you please provide guidance on this issue as soon as possible? Thank you.

—> Purchase or Repair:
#Atlas Copco by thein than oo on 2011-02-13 00:20
the display showed the inop and cannot run the unit.

—> Purchase or Repair:
#Atlas Copco by Weldon Rop on 2013-05-30 16:02
Atlas Copco is Excellent in manufacture, sale and service of a wide range of compressors

—> Purchase or Repair:
#Atlas Copco by Terschluse on 2013-02-11 09:39
The Atlas Copco GA45 1900.0590.74 controller unit is displaying unusual behavior in the warehouse.

—> Purchase or Repair:
#Atlas Copco by james mulqueen on 2011-07-13 19:58
machine trips from time to time with same fault convertor motor timeout need to know possible causes please have checked usual things rmba unit and cables crc counters count in units of 1on a only. turn power of and these reset some help please

—> Purchase or Repair:
#Atlas Copco by Gunawan s on 2011-03-14 06:12
problem when mesin on any comant inverter convert timw out

—> Purchase or Repair:
#Atlas Copco by P.NITHIYANANDAN on 2008-10-24 05:58
Kindly send the manuals related to this system

—> Purchase or Repair:
#Atlas Copco by Manuel Veliz on 2008-02-17 04:25
i need manual electronikon

—> Purchase or Repair:
#Atlas Copco by SHahbaz Latif on 2010-10-02 00:38
The Atlas Copco GA55/125 1900.0590.74 unit's controller malfunctioned mid-shift. Needs attention from the day shift maintenance team.

—> Purchase or Repair:
#Atlas Copco by M.kamran on 2015-09-08 07:37
dear siratlas copco ga 90 vsd give me information electrical manual thanksM.kamran

—> Purchase or Repair:
#Atlas Copco by Alan Irwin on 2012-11-20 03:57
The Atlas Copco Elecktronikon 1900-0590-12 unit is not working and needs maintenance.

—> Purchase or Repair:
#Atlas Copco by Omid on 2015-12-06 11:12
schematic diagram of ga50vsdthanksomid

—> Purchase or Repair:
#Atlas Copco by bayu pratamap on 2011-09-20 01:26
dear,May you give us some informations about manual operation and connection from elektronikon II for our part elektronikon II.Thank you

—> Purchase or Repair:
#Atlas Copco by Benjamin Foronda on 2006-07-20 09:16
Kindly share us technical manual of elektronikon part # 1900.0590.73 ed:04

—> Purchase or Repair:
#Atlas Copco by manjit singh wazir on 2011-07-09 11:24
just need servise manual and electrical diagram we have two compressor of GA 90 regards

—> Purchase or Repair:
#Atlas Copco by Eduardo Sanchez on 2009-11-23 18:42
I need the elektronikon II manual in order to change parameters.Thanks,Ed

—> Purchase or Repair:
#Atlas Copco by NILEAYSH GHODAKE on 2013-07-22 23:32
The Atlas Copco Elektronikon 1900 0701 05 unit in the shop is not working.

—> Purchase or Repair:
#Atlas Copco by Buckhaults on 2015-03-07 14:15
Can the Atlas Copco Elektronikon II 1900071012 Compressor Controller be repaired or bought? I'm trying to check this off my to-do list.

—> Purchase or Repair:
#Atlas Copco by supria on 2011-09-23 10:33
I NEED SERVICE & OPERATING MANUEL FOR ATLAS COPCO GA55THANKS.

—> Purchase or Repair:
#Atlas Copco by Sojitra on 2010-09-18 06:20
The Atlas Copco Elektronikon 1900070124 is a controller that is currently not working and needs attention from the maintenance team.

—> Purchase or Repair:
#Atlas Copco by Mark Krohn on 2013-08-16 13:01
One of the drives or boards on the Atlas Copco Elektronikon 1900070008 control panel has failed. Need immediate attention to get it back up and running.

—> Purchase or Repair:
#Atlas Copco by SAFAE HIBA on 2011-06-16 23:33
j\'aime atlas copco

—> Purchase or Repair:
#Atlas Copco by Carsten on 2011-05-28 18:17
Atlas Copco Elektronikon II displaying error code 1900 0710 12. Equipment currently down. Please advise on troubleshooting steps ASAP. Thank you.

—> Purchase or Repair:
#Atlas Copco by MOHAMMED HASSAN on 2010-09-27 12:58
The Atlas Copco Electronikon 1900059812 controller seems to be behaving strangely in the warehouse.

—> Purchase or Repair:
#Atlas Copco by chopade sopan sahadu on 2012-07-31 13:37
ga 160 capacity

—> Purchase or Repair:
#Atlas Copco by Michael on 2011-08-04 04:27
I have a GA10. 1998 model. The elektronikon board has a fault code 102 on the board. What does this mean as the machine will not run.

—> Purchase or Repair:
#Atlas Copco by OWEN on 2012-01-01 05:39
Received a downtime alert on Atlas Copco 1900-0700-08 controller, drive or board failure suspected. Investigating further, ETA update in 10 minutes.

—> Purchase or Repair:
#Atlas Copco by Slettemoen on 2011-04-16 13:39
Hi, we urgently need repair information for an Atlas Copco Elektronikon II 1900 0710 12 controller. It suddenly stopped working, and we can't find a replacement. Can you please provide details for repair? Thanks!

—> Purchase or Repair:
#Atlas Copco by Abdallah on 2013-01-28 16:07
I have 2 compressor Ga75 and 1 Ga55VsdI have an alarm with Ga55Vsd manfacturing year 2007The alarm is : inverter faliauerI need the soluation The compressor make 35000hr

—> Purchase or Repair:
#Atlas Copco by Mesaros Sandor on 2012-11-26 22:49
HelloI need a technical support for Your controller: a wiring diagram for MKIVCan I have it, pleasebest regardsSandorElektroProfessional comp.

—> Purchase or Repair:
#Atlas Copco by Gert Smith on 2010-01-02 10:28
We have the same problem. Can not use any key on the keyboard. Can not reset any alarms or use the uo and down keys. The display shows temperature element outut. The setting is 120 DegC and the real vakue is 36 DegC. The alarm led and the power led is flashing.Please help.Gert

—> Purchase or Repair:
#Atlas Copco by Karl Halder on 2011-08-06 11:21
The controller on the Atlas Copco Elektronikon II 1900 0710 12 is malfunctioning, affecting the production line. Urgent repair service is needed to resolve the issue and resume operations

—> Purchase or Repair:
#Atlas Copco by nadher on 2011-07-06 06:10
how can i reset the unit if the compressor shutdown due to rising outlet temperatur

—> Purchase or Repair:
#Atlas Copco by Roopnarine Jaikishun on 2009-05-03 16:34
hi i am asking u if u could please send me a copy of the operation and trouble shooting manual for the GA75 compressor (100 Hp).thank you.

—> Purchase or Repair:
#Atlas Copco by José Valdir dos Santos on 2013-08-16 22:32
The Atlas Copco Elektronikon 1900 0701 05 unit is still down. Please provide a

—> Purchase or Repair:
#Atlas Copco by ijenebe anthony on 2010-01-04 11:16
how do i get my GA22 atlas copco compressor started, it is indicating some form of alarm that i cannot decode as the display is not in English language. Probably we can change the language setting?thanks.

—> Purchase or Repair:

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.