Atlas Copco Service & Repair Forum

The Atlas Copco Elektronikon II 1900 0710 12 controller malfunctioned today causing unexpected downtime. We need to address this issue

—> Purchase or Repair: Ticket Image

— Posted by Dale Parrish on 2011-04-10

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "Atlas Copco"

If you need your Atlas Copco unit tested or repaired,
give us a call at 1-336-969-0110.
We offer free estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 1316 Comments

#Atlas Copco by dhayalan on 2011-05-26 06:53
sir, please send the manual of elektronicon ii to service atlas capco compressor.thank youwith regardsDhayalan+91 9952760682

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by mngwenya on 2012-07-29 16:52
which port on the regulator is reserved for CAN connection to the COMBOX-P?

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by aamir on 2013-07-05 15:09
we are using GA75 Atlas Copco the ELEKTRONIKON MODULE showing fault \'system failure\' so please give us some solution to rectify above problem thanks and regards

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by rogerio on 2012-06-01 12:28
preciso do manul de alrmes do elektronicon do compressor GA-90 por favor se possivel for

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Orobona on 2014-10-31 07:57
Atlas Copco Elektronikon II 1900071011 control module is displaying error code E-XXXX and machine is not turning on.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by samir shah on 2013-12-24 04:54
WE NEED TO REPAIR THE DRIVE OF ATLAS COPCO MAKE SAM-DA-400-50N-P4N-E

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by David Downes on 2011-09-08 14:28
Electronikon shows converter failure 001.Siemans drive shows F0001. I was told that is motor failure.Test motor w/ 500 volt megemeter. showed no leakage to ground.Tested w/ ajustable AC Volt induction meter, trips @ 1700 volts / 10 meg ohms also trips trips @ 500 volt / 3 meg ohmsPulled fan cover, m…Purchase or Repair: Ticket Image...
Show More
➡️ Reply
#Atlas Copco by rickey on 2009-08-17 15:02
The only thing that show up on the display is 110200000000

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Tracey Norouziani on 2012-12-03 05:48
Hi I was wondering if possible if you have the electrical diagram for the ga 45 atlas copco. I\'m getting a error saying \"run phase sequence\" Can you PLEASE HELP? if you have the diagram would you please send me a copy.Thank You Tracey

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Mohammed Hosawi on 2012-09-15 03:17
Hello, We are facing an issue with our Atlas Copco Elecktronikon 1900-0590-12 controller and require repair/replacement. Could you provide us with repair information or suggest a solution? We appreciate your

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Elvis rojas on 2021-12-13 01:01
Buenas noches,muy buenos equipos, requiero manual de programación , no permite aran que manual, solicito clave para su arranqué automático

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by p.srinivasu on 2008-06-30 14:51
power off with out any triping

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Anil shinde on 2010-09-15 07:35
All programmes are well explained and good for reference.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by janusz on 2009-02-16 11:53
We have 2 compressores (manufactured by Atlas Copco) with model of engine XAS 175 and XAS 175N. This compressores are about 10 years. Where I can find user manual?

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Jason on 2016-07-28 08:51
I have same problem with GA90VSD.So please tell me how about for repair.Thank you so much!

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by anupam on 2009-12-23 07:00
It\'s a very good compressor ,reliable and suitable for our requirement.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by albertoli on 2010-12-22 20:43
The Atlas Copco Electronikon 1900059812 controller on unit down mid-shift. Needs attention ASAP. Night shift maintenance crew out.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Elvis rojas on 2021-12-13 03:21
Buenas noches,muy buenos equipos, requiero manual de programación , no permite aran que manual, solicito clave para su arranqué automático

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by amar nath chanda on 2011-10-14 15:07
I need controller manual to know the symbol used in controller. like a diagonal arrow in a square box.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Raul L. Virtudaqzo on 2008-04-26 06:36
Dear Sir, I need the connection diagram of our compressor model ZR110. Thank you so much and more power in your company.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Nasir Shamdar on 2022-03-29 09:22
I need some information regarding atlas copco dryer unit

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by kenan saruhan on 2009-11-23 00:47
ga55 manual

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Euler Resende on 2011-12-21 04:25
Please provide the details of the Atlas Copco Elektronikon II 1900 0710 12 controller so we can check if it is still supported or if replacement parts are available. Thank you.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Eric Perkins on 2011-04-08 10:54
I have an Elektronikon unit that has lost its memory and programming. Would you be able to assist in repairing and reprogramming.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Hope Uwaya on 2021-07-23 08:39
Kindly help with schematic of module ELEKTRONIKON for SF11 Atlas Copco Compressor.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by joe garar on 2013-02-04 08:01
appear on the display of control panel 100300000000 for ga55

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by ibraheem megahed on 2011-05-20 12:05
We have a Atlas Copco GA 18 FF w/ Elektronikon ll control. But we have no manual for the Elektronikon control. Could I get this on pdf file?

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by DKIOUAK on 2011-03-01 12:21
bonjourVeillez m\'envouyer le manuel d\'utilisation et de maintenance du compresseur GA 30 Atlas copco.Bien cordialement.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by PHAM HAI on 2011-09-01 04:30
Dear Sir, I am from VN, I have one machine Ga22 ( year 2001)now, controller alarm: system failure 11 & 104. machine can not run.I turn off the power and turn on but machine can not run!Pls, tell me, what must I do?Thanks & best regards,

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by paresh on 2012-01-12 03:38
i have atlas copco GA160 Werror code 110300000000what will we do for remove this error code

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Salaheldin elserwy on 2017-01-21 10:46
We need mechanical maintenance catalog for atlas copco compressor model Ga75+Ga 710 pack

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Junaidi Ismail on 2010-11-18 02:30
The Atlas Copco Elektronikon 1900070124 controller malfunctioned mid-shift. Please check and troubleshoot tomorrow. Thanks.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Mario Canaza on 2012-04-12 19:31
por favor requiero con urgencia los documentos referidos al compresor GA160-10AP-380V/50Hz, tengo problemas con la salida de aire que entrega humo.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Hoang Thanh Tung on 2011-08-12 03:29
Dear Sir/Madam ;we are using yours GA7FF Compressors. We need this units\' documents as soon as possible. Please send me GA7FF Compressors\' Installation Operation and Maintenance Manuals.Thanks and best regard.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Satish Rane on 2009-09-03 05:58
I wanted to activate auto restarting for Atlas Copco after power resumption.To do this I required the above mentioned Manual

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by jami on 2014-12-14 08:04
Dear sir sir\'si have a compresor module ga11c at this time on display show system failure 106 and do not workplease help me to fix this problema.jami

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Aland on 2010-04-07 16:55
Hey, just a heads up - looks like the controller on the Atlas Copco GA55/125 (Part 1900.0590.74) just took a dive. Need to swap out one of the drives or boards ASAP.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by HAMAMI DJAMEL on 2013-04-28 12:18
MANUEL OF GA22FFand problem, Element output hot air

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by hossein hosseinzade on 2013-04-01 11:26
Hello I have one compressor air Atlas Copco GA55 type 1900-0582-03 .This compressor has elektonikon display.Please send me manual of this.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Barduzzi on 2010-08-17 20:24
The Atlas Copco GA55/125 1900.0590.74 is displaying Error Code E001. Equipment is down due to controller issue. Please advise on troubleshooting steps or repairs needed urgently. Thank you.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by M.Boopathy on 2010-06-05 06:44
NAME PLATE DETAILS OF ABB MOTOR USED FOR COMPRESSOR VFDABB Oy MOTORS Vaasa, Finland3 Phase Motor M3BC280SMC4B5IEC 75FF500M31095 - 732008No 0810-010537805FWP 400 VD 95 HzVHzKWr/minACOS phiDuty400D951022842240 - S9Prod Code3GBC282230-BXGAC411CT 635 NM1500 - 4185 rpm1080420911CP 160 KW4185 - 4500rpmNma…Purchase or Repair: Ticket Image...
Show More
➡️ Reply
#Atlas Copco by NITIN THEURKAR on 2010-10-07 11:09
Pl. send me Elektronikon user manual for GA 22 compressor.Thanks & RegardsNITIN

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by kousar pasha on 2014-09-27 17:45
Atlsas copco compressor is a number 1 compressor maintanence proper give more life

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by maintenance on 2009-02-02 14:24
atlas copco ga45 serie all316282nous essayons de cabler une commande externe au local compresseur

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Miftah on 2012-03-07 10:41
We have using ZR 250 compressor since 5 year,and we need operating manual for our compressor, serial no 080239 year of manufacturer 2003Kind regardsMIftah

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by poz on 2013-08-10 08:32
One of the drives or boards on the Atlas Copco Elektronikon 1900070008 just failed, need to troubleshoot and replace it ASAP to keep the compressor running smoothly.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by ashraf ali on 2011-08-21 16:36
plese send complete user manual inverter&plc

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by george on 2011-05-10 07:16
the module on condition only display back light glow.no message displayed

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by Evangelist on 2011-06-24 00:36
My Atlas Copco Electronikon 1900-0701-04 Display Unit is not functioning properly. Need help finding a repair technician as soon as possible. Thank you.

—> Purchase or Repair:
➡️ Reply
#Atlas Copco by saeod on 2011-05-14 19:59
for univercity

—> Purchase or Repair:
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.