dear sir, we have 4 instrument air compressor operating in MCC, No 1 compressor is master control for 3 compressors.we have one problem in atlas copco instrument air compressor no 3 this is not communicating with instrurment air compressor 1 and not sending to DCS also it means all process parameters like lube oil pressure,air in/outlet temp and omore analog out puts not showing in DCS but locally everthing is ok question is how to check communication for lan to Field bus to modbus?normally connection is Lan to field bus to modbus but reamaining compressors that is 1 2 4 are communicating good but no 3 is not communicating to no 1 compressor and DCS also how to trouble shoot?Note: Master compressir is recieving all communications from each compressors and finally sending to DCS through MOD busplease give me ur advise to trouble sohoot by usAtlas copco model no :ZT 200Electronikon PLCtype : screw copressorstages : 2stage
β> Purchase or Repair:
If you need your Atlas Copco unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
π Rush repair shipments only β no walk-ins.
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
π¦ Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.
β> Purchase or Repair: