Atlas Copco Service & Repair Forum

We have replaced the module of G11A with the module of G11FF , kindly do advise as it is giving sensor light ,

—> Purchase or Repair: Ticket Image

— Posted by Muhammad Mansoor on 2009-07-16

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "Atlas Copco"

If you need your Atlas Copco unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110


Recent 1316 Comments

#Atlas Copco by Nigel Poole on 2010-01-07 02:29
Im after the user manual for the Electronikon II controller, specifically need to change somesettings on the unit to control the GA75VSD Unit.Manual should have description in it for the direct, indirect setpoints etc.Can any one send me a copy via e-mail please.ThanksNige.

—> Purchase or Repair:
#Atlas Copco by Roy Cheeseman on 2008-10-14 19:18
Could you tell me how I can get user manual elektronikon regulator serial number is 06080400009. For an Atlas Copco air compressor model ZE55-2.0.Our compressor is shutting down with no trouble code; we check all of our ends and found nothing. We had Atlas Copco Tec come out and found nothing, they …Purchase or Repair: Ticket Image...
Show More
#Atlas Copco by JOHNNY MARTINEZ on 2014-11-21 05:12
Hello I\'m johnny from mexico, I have a little problem whit a machine atlas copco GA75 FF , In the display of Elektronikon , appear a error , the number is 100300000000 . thhank so much for you help beste regards

—> Purchase or Repair:
#Atlas Copco by amine on 2010-11-18 11:31
please would you mind sending me the manual user for atlas copco ZT110 regards

—> Purchase or Repair:
#Atlas Copco by devinder singh rawat on 2010-02-20 10:42
Dear sir,We want ELEKTRONIKON MANUAL please help methanking you

—> Purchase or Repair:
#Atlas Copco by Robert Ward on 2008-04-16 14:37
In need of a user manual for Electronikon model 190-0701-02.

—> Purchase or Repair:
#Atlas Copco by tarek naga on 2007-12-19 07:16
hiCould you please send a pdf manual copy for GA22 compresor

—> Purchase or Repair:
#Atlas Copco by hadi on 2009-11-02 02:53
hello,dear! my company have two compressor model ga55 ff. and this compressors is good product. But I have problem abaut \" dp oil separator\". It problem is pressure to high. To high from maximum servise [ 1 bar ].Please, can you help for this problem?

—> Purchase or Repair:
#Atlas Copco by Rumen Nanev on 2009-08-11 18:32
I need more information for Atlas Cotco GA55

—> Purchase or Repair:
#Atlas Copco by STEVEN LAMBERT on 2009-08-25 20:05
FROM A ELEKTRONIKON TO ELEKTRONIKON II

—> Purchase or Repair:
#Atlas Copco by Jesus Lara on 2011-09-13 22:28
we need some manual parts for repair this equipment?, you can help us and send us for this email, thanks

—> Purchase or Repair:
#Atlas Copco by M. Imran Amin on 2012-05-19 08:33
Dear SIrWe have problem in Atlas Compressor GA50 VSD , THe copressor ELKTONE Shows an Error 7301 and 7401. Kindly help out us to solve this problem and what is the meaning of 7301 and 7401.ThanksImran

—> Purchase or Repair:
#Atlas Copco by Darek on 2012-06-19 18:13
I need manual for GA15ff

—> Purchase or Repair:
#Atlas Copco by eng ahmed alshahat on 2016-01-15 08:14
part no:1900059811 ed:03sn:003700001

—> Purchase or Repair:
#Atlas Copco by m.k on 2008-07-08 08:22
realy i need itgood

—> Purchase or Repair:
#Atlas Copco by dasun on 2008-08-01 08:36
Electronikon 1 user manual is required

—> Purchase or Repair:
#Atlas Copco by ramawat on 2012-09-21 16:47
The Elecktronikon 1900-0590-12 controller on the production line is malfunctioning, causing delays and affecting our output. We need immediate assistance to resolve this issue and get the production line back up and running efficiently.

—> Purchase or Repair:
#Atlas Copco by LE MINH DONG on 2011-07-20 06:56
Dear,Pls sent to me Maintenance Manual of Atlas Copco, model GA55.Thanks.

—> Purchase or Repair:
#Atlas Copco by Amgad Fayek on 2009-01-14 06:22
Need for spare part manual for GA11 1999

—> Purchase or Repair:
#Atlas Copco by Pelliculages de l\'ouest on 2010-01-14 08:24
We have a Engine GA 55 VSD with a elektronikon 2 .Can you send the doc from this Elektronikon 2 for read informations .We have no more the documentation.Best regard

—> Purchase or Repair:
#Atlas Copco by b_alaki on 2008-03-23 06:09
hiwe have 4 atlas copco ga7-10 our in our site and we need compressor and compressor controller (elektronikon cst584) user manual and if it possible the controller schematic diagramthanks with the best regards

—> Purchase or Repair:
#Atlas Copco by M ASGHAR on 2010-11-30 08:32
I USE ATLAS COMPRESSOR I NEED Operation passwared PLEASE TELL ME

—> Purchase or Repair:
#Atlas Copco by Paul Gunkel on 2009-03-13 15:59
I have a newer GA 55 plus compressor and lost my CD that explains evry thing about the compressor and was wondering if I could by another one?

—> Purchase or Repair:
#Atlas Copco by Behzad Akbari on 2008-10-05 12:44
Hi,I\'ve lost the Elektronikon Atlas Copco manual.

—> Purchase or Repair:
#Atlas Copco by iqbal on 2010-11-23 05:28
Kindly provide detailed operation manual of the above controller. We have a same controller installed on our GA-45 compressor but your people did not provide the above manual alongwith it. With thanks in anticipation.

—> Purchase or Repair:
#Atlas Copco by PREMARATNE W.P. on 2010-02-16 12:33
Dear Sir,We have 3 No. of this type of air compress, and one of this can\'t start. the fault indication was (104 ) system faulty I checked input voltage and tightened call connection of regulator but all are OK Again i tried but not start. Can you please tell what i wants to check more. When i repla…Purchase or Repair: Ticket Image...
Show More
#Atlas Copco by hieu le minh on 2008-03-12 12:35
I want to control elektronikon panel of air compressor model ZT110.Could you tell me how I can get user manual elektronikon regulator.Pls, feedback to me as soon as.Thanks and best regards.Hieu Le MinhBritish American Tobacco- Vinataba (JV) Ltd.,Vietnam

—> Purchase or Repair:
#Atlas Copco by mohammad dadkhah on 2015-02-02 10:39
helloi want the electrical wiring of ga75 i dont know the wiring between the sockets 2x1 ,2x2,...2x9 of elektronikon control board.

—> Purchase or Repair:
#Atlas Copco by nassim zouaoui on 2010-12-20 16:01
please send us the maintenance manual for atlas copco , oil type, frequency change, oil filter etc...

—> Purchase or Repair:
#Atlas Copco by CESAR RIVAS on 2010-08-16 19:33
por favor necesitamos el manual del panel elektronikon del compresor atlas copco GA55, ya que el mismo no presenta lectura solo indica varios numeros 10030000000 en la pantalla.

—> Purchase or Repair:
#Atlas Copco by ch azhar on 2012-08-29 12:59
We have language problem in electronicon II model provided with compressor GA II FF.How we program the English Language.

—> Purchase or Repair:
#Atlas Copco by Aboua Guy serge on 2012-11-01 08:44
Juste savoir que signifie le code 110300000000 du GA90?

—> Purchase or Repair:
#Atlas Copco by Ivan Biondic on 2010-08-07 11:00
Dear Sirs,Please send to me on e-mail manual for Elektronikon I.Best regards.Ivan

—> Purchase or Repair:
#Atlas Copco by barhoumi on 2011-05-26 20:55
le meilleur marque international

—> Purchase or Repair:
#Atlas Copco by kirankumar on 2010-04-16 07:42
I want the electrical circuit diagram for GX 7 FF model atlas compressorRegards,Kiran

—> Purchase or Repair:
#Atlas Copco by Abdul Hafeez on 2008-06-26 16:23
if any one problem with screw compressor of any brand.... please do not hesitate to contact us.... regards A H S

—> Purchase or Repair:
#Atlas Copco by paresh on 2012-01-12 03:38
i have atlas copco GA160 Werror code 110300000000what will we do for remove this error code

—> Purchase or Repair:
#Atlas Copco by h on 2011-03-11 03:32
Dear Sirs,Please send to me on e-mail manual for Elektronikon I.Best regards.

—> Purchase or Repair:
#Atlas Copco by Galien on 2011-03-11 04:32
One of the boards in the Atlas Copco Electronikon 1900-0701-04 display unit has failed, need replacement ASAP to prevent downtime.

—> Purchase or Repair:
#Atlas Copco by prakash on 2010-05-08 08:03
wiring diagram

—> Purchase or Repair:
#Atlas Copco by cal on 2012-08-05 10:24
My Atlas Copco 1900-0700-08 controller is displaying an error code and not responding. Looking for a technician who can diagnose and repair the issue

—> Purchase or Repair:
#Atlas Copco by FRANKLIN ALARCON on 2009-11-15 00:37
1.- GA75 AIR COMPRESSOR ELEKTRONIKON MANTENANCE MANUAL2.- GA90 AIR COMPRESSOR ELEKTRONIKON MANTENANCE MANUAL3.- PLEASE SEND THE ELECTRONIKON I AND II MANUALSincerelyFranklin Alarcon

—> Purchase or Repair:
#Atlas Copco by Abdul Hafeez on 2008-06-26 16:16
Replace fan thermal switch.... i think problem is not in the module but it is in the thermal switch only... rgds. A H S

—> Purchase or Repair:
#Atlas Copco by SHahbaz Latif on 2010-10-02 00:38
The Atlas Copco GA55/125 1900.0590.74 unit's controller malfunctioned mid-shift. Needs attention from the day shift maintenance team.

—> Purchase or Repair:
#Atlas Copco by Michael on 2011-08-04 04:27
I have a GA10. 1998 model. The elektronikon board has a fault code 102 on the board. What does this mean as the machine will not run.

—> Purchase or Repair:
#Atlas Copco by adnan siddiqui on 2010-10-01 19:00
and error detail year manufacture date 1997

—> Purchase or Repair:
#Atlas Copco by edgar on 2010-09-30 22:50
please, need manual repair de controler electronikon serie: 06983500028part. nr. 1900 0701 23than youedgar

—> Purchase or Repair:
#Atlas Copco by MARK SCHIMPLER on 2017-07-28 20:27
CAN YOU PROVIDE AN ELECTRICAL DRAWING FOR THE CONTROLLER ON A GA90 AIR COOLED COMPRESSOR.CONTROLLER SN: 06033600018PART #: 1900 0701 25SUPPLY VOLTAGE: 24VACRELAY OUTPUTS: 250VAC

—> Purchase or Repair:
#Atlas Copco by Hope Uwaya on 2021-07-23 08:39
Kindly help with schematic of module ELEKTRONIKON for SF11 Atlas Copco Compressor.

—> Purchase or Repair:
#Atlas Copco by samir patel on 2015-05-20 15:40
when start pb pressed power off alarm coming and software restarting soplease send user manual

—> Purchase or Repair:

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.