Autonumerics Inc. Service & Repair Forum

I have been running a Shizouka 3 axis mill for a particular job for 15 years and have run into a X motor control problem. The X axis vibrates in place at any feed rate right now. I have swapped 2 stepper cards and both x and y motor drives in the mainpower box with no changes in result. The motor itself turnsrelatively freely without powered up. What would be my next step. I have I/O boards from a 1970double spindle unit available but I hesitate to switch them out.John

— Posted by John Adelmann on 2020-09-11

Reply🗨️Ask a New Question Below❓

If you need your Autonumerics Inc. unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 1 Comments

#Autonumerics Inc. by John Adelmann on 2020-09-11 19:34
I have been running a Shizouka 3 axis mill for a particular job for 15 years and have run into a X motor control problem. The X axis vibrates in place at any feed rate right now. I have swapped 2 stepper cards and both x and y motor drives in the mainpower box with no changes in result. The motor it...
Show More
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.