Creonics Service & Repair Forum

hello........ we have a vulcan plasma table that is run by an Aircotron 1000 made by Creonics, Hanover NH.........it stopped suddenly during a burn, giving a message E- power lost when I turn the machine off, and then back on again, after 4 seconds, I get the same message, and the machine is off ......... is there anyone in your company that can help us with this problem?thank you in advance, john k paterson sheet metal

— Posted by john koromhas on 2006-08-07

Reply🗨️Ask a New Question Below❓

If you need your Creonics unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 2 Comments

#Creonics by john koromhas on 2006-08-07 17:44
hello........ we have a vulcan plasma table that is run by an Aircotron 1000 made by Creonics, Hanover NH.........it stopped suddenly during a burn, giving a message E- power lost when I turn the machine off, and then back on again, after 4 seconds, I get the same message, and the machine is off ......
Show More
➡️ Reply
#Creonics by eric brown on 2012-05-14 18:30
need information on wiring to plasma cutter
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.