Dyna Mechtronics Service & Repair Forum

my dyna 44 m after initializing sporadically refuses to move in any axis sometimes it will move limit to limit in one axis and then not go in any axis would it be possible to get a little tech advice and if not able to solve problem over phone or by e-mail research cost for field repair???

—> Purchase or Repair: Ticket Image

— Posted by carl shalley on 2009-02-24

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "Dyna Mechtronics"

If you need your Dyna Mechtronics unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110


Recent 1 Comments

#Dyna Mechtronics by carl shalley on 2009-02-24 23:14
my dyna 44 m after initializing sporadically refuses to move in any axis sometimes it will move limit to limit in one axis and then not go in any axis would it be possible to get a little tech advice and if not able to solve problem over phone or by e-mail research cost for field repair???—> …Purchase or Repair: Ticket Image...
Show More

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.