Dynamote for Service call 1-336-969-0110 at Industrial Electronics Repair

Dynamote Service & Repair Forum

The electrical system was modified by dynamote, sticker said to contact dynamote before makeing any repairs. need to know where the voltage regulator has been located. the vehicle is a 1989 bucket truck.

— Posted by James R Pacenti on 2009-11-14

Reply🗨️Ask a New Question Below❓

If you need your Dynamote unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 27 Comments

#Dynamote by Dwayne Lange - Sunspot Solar on 2005-10-18 01:33

I am a solar power supplier / installer located in Adelaide, Australia.I have had a client bring in a \"Bravo\" QBC 1012 inverter / charger manufactured by Dynamote Corporation.My local inverter repairer is unable to find any specs on these products, but has been able to confirm that the M...
Show More

#Dynamote by Bill on 2006-03-04 12:15

can you tell me the correct fuses for my power invertermodel# A20-50D

#Dynamote by RYAN WILSON on 2006-06-15 15:04

HAVING A PROBLEM WITH POWER GOING IN, BUT NO POWER COMING OUT. POSSIBLY SOLENOID? MODEL # A40-120A/150

#Dynamote by Ty Cummins on 2006-09-16 04:52

need to see if you would have a wiring diagram for installation for a dynamote inverter model number a30 70b any help would be great. thanks for your time. Ty

#Dynamote by Lloyd Morris on 2006-10-03 15:01

A customer brought me a Dynamote President B10-KKK Inverter It trips the reset as soon as you connect 12 volt power to it . I suspect the diodes are fried but have no schematic or anything to help. can you be of assistance?

#Dynamote by Barry Coker on 2006-11-03 20:22

I am looking for a diagram to hook up a Dynamote Model#A40-120Serl.#811734. This unit is on a 1981 Mack fire truck The trucks eng.was just rebuilt and the inverter didnot work when the truck was picked up. I have no diagrams to Know if I have power at all points needed onthe D C side. Your help woul...
Show More

#Dynamote by eric on 2006-12-18 01:04

I bought it used ,it works but I would like to know what output wattage it has.I tried to run 2 - 500 watt lights and it would not do it,then I ran a 75 watt bulb on a full charged 1000amp batt.,It ran 37min then tripped low voltage.I recharged the battery, hooked it it to an APC battery backup (100...
Show More

#Dynamote by Ajendra Prasad on 2007-05-07 20:45

Hi , I have a Dynamote power inverto model # B10KKK-TINPUT 14.2 VDCOUTPUT 120VAC10AMPS 60HZMy invertor doesnt come on at all, I have done some test on power supply from battery to circuit breaker and have got 14v there but after the tranformer there is no out put , this unit has a remote connection ...
Show More

#Dynamote by Ajendra Prasad on 2007-05-07 20:50

Hi , I have a Dynamote power inverto model # B10KKK-TINPUT 14.2 VDCOUTPUT 120VAC10AMPS 60HZMy invertor doesnt come on at all, I have done some test on power supply from battery to circuit breaker and have got 14v there but after the tranformer there is no out put , this unit has a remote connection ...
Show More

#Dynamote by DENNIS BERNARD on 2007-06-27 21:41

i have a dynomote m a60-120 sn-810189 12 dc system i need to know how to wire my delco remy alternator into it.the alternator model is 111740 s/n 801122 type 150 amps 145.please help. this is for a fire truck and is out of service.thanx

#Dynamote by Ray Mills on 2007-07-18 00:48

Hi AJ: There is a female 6 connector plug You need to momentery short out two of the wires. If you want to give me a call I will give you more information. 904-733-9242 or email me.

#Dynamote by James Beaman on 2007-07-28 14:02

Any and info including schematics if that is possible. We would like to use in the field. Thanks, James

#Dynamote by Joel Moorman - Moorman Electric on 2007-11-26 19:52

Is it possible to obtain a service manual for a Dynamote A30-70D option LD/GF120? Only 40V output and stop button does not shut unit off. Also need a green connector sleeve. If you could help us out, it would be greatly appreciated. Looking forward to hearing from you. Thank You, Joel Moorman Moorma...
Show More

#Dynamote by Harry Trottier on 2008-01-16 17:38

Is it possible to get a manual for a Dynamote A/L25-120 Inverter?

#Dynamote by Mitchell Vavra on 2008-02-14 14:24

I bought a used Derrick Digger body, and it has a A60-120D with options/LD/GFI120. The wires were cut off the old chassis and I am currious on how to correctly connect them to my Chassis. Any help would be appriciated.Thanks,Mitch Vavra

#Dynamote by Tina Gilbert on 2008-07-24 14:16

Wiring instructions needed for remote. Can you assist me?

#Dynamote by steve bosco on 2009-10-24 17:37

I have this inverter but no manual to install it. can you help me find the paperwork to properly connect this unit? the wires are cut but I have know idea how to connect it to my vehicle.

#Dynamote by James R Pacenti on 2009-11-14 19:58

The electrical system was modified by dynamote, sticker said to contact dynamote before makeing any repairs. need to know where the voltage regulator has been located. the vehicle is a 1989 bucket truck.

#Dynamote by richard on 2010-01-21 18:49

A friend of mine aquired an inverter that can be installed to a vehicle. when it was found in a box in an old barn,the box and the instructions inside, have deteriorated. Is there anyway to find the manuel.

#Dynamote by Ed Cook on 2010-02-09 00:23

I purchase a 1980 Amblance E-350 Ford It has a Power Gaurd Mod. G-B10-10 Ser# 79213 it is on top of Dynamote 1.0 KVAMod. # B10-KKK Ser.# 800226 It is not connected any more to the truck can you send my the instruction manual of it use and connection instruction. If you can help me I baught it for my...
Show More

#Dynamote by RUSSELL LEYRA on 2010-09-07 11:52

GOOD MORNING, I AM LOOKING FOR SOME PRICING ON A REPAIR OR REPLACEMENT FOR A CUSTOMER\'S DYNAMOTE A40-120D/240.I AM NOT SURE WHAT IS WRONG WITH THE UNIT OTHER THAN IT DOES NOT WORK. THANK-YOU FOR YOUR TIME RUSS

#Dynamote by Dan Harding on 2010-12-06 22:25

Can I get a manual and wiring diagram for this unit? Our fire dept. just bought a used rescue truck with a unit on it.

#Dynamote by Jimmie Morgan on 2015-03-05 18:01

In a fire truck we bought Puts out about 40 volt Ac Mfg 1995 Want to know if fixable. Thanks Jim Goodman Area Fire Protection District

#Dynamote by AHMED on 2015-03-07 08:15

the wiring diagram and asking about the out put Ac 220 sine wave and asking of the sine wave does it was pure sine wave or not ?

#Dynamote by David Wardle on 2015-12-31 19:54

Do you service Dynamote Static Inverters or possibly have a schematic for this unit: Dynamote Brutus TB32-24. Described as : 3200 watt, 24 volt battery powered inverter, hybird hi-low frequency.......high frequency H bridge feeding 60 Hz. transformerThanks, David

#Dynamote by Julia Lunstra on 2022-07-18 02:22

My husband recently passed away and while cleaning the garage I came across this item. It is a Dynamote B20-12 with CD, LVCO. What is it? What is it good for? How much is it worth for me to sell?Any help that you could provide would be extremely appreciated.julia

#Dynamote by James Wooldridge on 2024-11-26 06:25

Trying to wire the remote switch inverters not working without it

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.