Ferrocontrol Service & Repair Forum

Subject Urgent Request for Repair Information on Ferrocontrol D-32049herfordHi ,I'm reaching out on behalf of a colleague who is experiencing issues with a Ferrocontrol D-32049herford unit. Unfortunately, the specific problem is unknown, but they need a replacement quickly. Could you kindly provide repair information for this model as soon as possible?Thank you for your

— Posted by Biswajit on 2020-08-16

Reply🗨️Ask a New Question Below❓

If you need your Ferrocontrol unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 6 Comments

#Ferrocontrol by John H Smith on 2007-12-07 15:47
I need cables (encoder and motor) to connect a DARC S12(35-060800) to a AC servomotor(HD142e6-130, 35161701).The cable part number are:70-25060070-251500
➡️ Reply
#Ferrocontrol by Ed Puckett on 2009-03-04 16:08
We have an Elumatec MGS245 saw with an E550 controller. The controller uses a Kontron MOPSlcd6 PC/104 processor and a Ferrocontrol fieldbus card (all of these are German companies). I think that the fieldbus card is out. I think that the part number for the card is 91027100, but I\'m not sure.We nee...
Show More
➡️ Reply
#Ferrocontrol by An, Yuping on 2009-07-27 16:04
Type: s02-00-2e, current controll error
➡️ Reply
#Ferrocontrol by Brian Borst on 2010-01-05 13:45
We have an Elumatec MGS244 saw with an E550 controller. The controller uses a PC/104 processor and a Ferrocontrol fieldbus card (all of these are German companies). I think that the fieldbus card is out. I think that the part number for the card is 91027100, but I\'m not sure.We need either a replac...
Show More
➡️ Reply
#Ferrocontrol by Eric Haffner on 2012-07-19 02:59
We have an Elumatec SBZ122, and the monitor has gone dark.I would like to repair the display instead of replacing it (cost).Monday evening I installed a new display panel, and it worked on Tuesday, but not on Wednesday. I suspect the power supply, however the power supply is controlled by another mo...
Show More
➡️ Reply
#Ferrocontrol by Biswajit on 2020-08-16 00:00
Subject Urgent Request for Repair Information on Ferrocontrol D-32049herfordHi ,I'm reaching out on behalf of a colleague who is experiencing issues with a Ferrocontrol D-32049herford unit. Unfortunately, the specific problem is unknown, but they need a replacement quickly. Could you kindly provide ...
Show More
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.