Fieldpiece Service & Repair Forum
Hi i\'ve tried several times to cailbrate my Fieldpiece HS26. I can only get it to go down to 200V and thats as far as the pot screw goes. should I send it in to you? Or is there something else I can do. Thank you Ben F Graves. Senior Lab Tech-Earthsytems South West, Bermuda Dunes California92203 USA.Phone 760-345-1588 EX-3316
—> Purchase or Repair:
Reply🗨️Ask a New Question Below❓
Recent Comments Search: "Fieldpiece"
- Fieldpiece → Fieldpiece My FieldPiece sent to you did you recive it ↗
- Fieldpiece → Fieldpiece Calibration unalbe to bring it down to 1.900V ↗
- Fieldpiece → Fieldpiece hs meter ↗
- Fieldpiece → my fieldpiece meter blown out ↗
If you need your Fieldpiece unit tested or repaired,
give us a call at 1-336-969-0110.
We offer free estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110
Recent 4 Comments
hi I sent my HS-26 to you fro Repair did you recive it . Please let me know Thanks Ben
—> Purchase or Repair:
—> Purchase or Repair:
My meter will not read amps, it read volts and every thing else but when it comes to amps the meter just scales from 0-300 over and over and when clamped around a wire it will still not read amps, is this worth repairing or can it be repaired any estimate of what it would cost?—> …Purchase or Repair: 
...
Show More
Show More
my fieldpiece HS 35 blown when i tried to used it to read microwave voltage.i replaced the fuse but its still not working.i realised i have used it over the maximum rating which is 700 volt ac.but i assume the fieldpiece has some protection again it.
—> Purchase or Repair:
—> Purchase or Repair:
Show More