Fieldpiece Service & Repair Forum

my fieldpiece HS 35 blown when i tried to used it to read microwave voltage.i replaced the fuse but its still not working.i realised i have used it over the maximum rating which is 700 volt ac.but i assume the fieldpiece has some protection again it.

—> Purchase or Repair:

Reply🗨️Ask a New Question Below❓

• Fieldpiece → Fieldpiece My FieldPiece sent to you did you recive it ↗
• Fieldpiece → Fieldpiece Calibration unalbe to bring it down to 1.900V ↗
• Fieldpiece → Fieldpiece hs meter ↗
• Fieldpiece → my fieldpiece meter blown out ↗

Recent 4 Comments

#Fieldpiece by David on 2008-12-24 01:36

My meter will not read amps, it read volts and every thing else but when it comes to amps the meter just scales from 0-300 over and over and when clamped around a wire it will still not read amps, is this worth repairing or can it be repaired any estimate of what it would cost?—> …Purchase or Repair: ...My meter will not read amps, it read volts and every thing else but when it comes to amps the meter just scales from 0-300 over and over and when clamped around a wire it will still not read amps, is this worth repairing or can it be repaired any estimate of what it would cost?

—> Purchase or Repair:
Show More

➡️ Reply

#Fieldpiece by Benjamin F Graves on 2009-09-18 17:19

Hi i\'ve tried several times to cailbrate my Fieldpiece HS26. I can only get it to go down to 200V and thats as far as the pot screw goes. should I send it in to you? Or is there something else I can do. Thank you Ben F Graves. Senior Lab Tech-Earthsytems South West, Bermuda Dunes California92203 US…Purchase or Repair: ...Hi i\'ve tried several times to cailbrate my Fieldpiece HS26. I can only get it to go down to 200V and thats as far as the pot screw goes. should I send it in to you? Or is there something else I can do. Thank you Ben F Graves. Senior Lab Tech-Earthsytems South West, Bermuda Dunes California92203 USA.Phone 760-345-1588 EX-3316

—> Purchase or Repair:
Show More

➡️ Reply