Holzma Service & Repair Forum

Machine not finishing \"initialization\".It has the old small screen \"operator panel\" BRRTGR31-OF.Sequence of events:1- machine main breaker is turned to ON.2- +- fourteen seconds later, there is a glitch to the LEDs switches.3- the \"HOLZMA\" logo is displayed on the small screen.4- operator stays waiting for the 2nd glitch on the LEDs and the black boxes on the screen indicating the initialization is finished. Number 4 above never happen.There are no errors on the panel. Removed all boards but PLC and Screen I/F MC02 = same result. Any suggestions?

— Posted by Rolando Rivera on 2015-11-05

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "Holzma"

If you need your Holzma unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110

Recent 5 Comments

#Holzma by Ramunas on 2018-03-20 11:23
Replace green battery in comunication board.
➡️ Reply
#Holzma by Rolando Rivera on 2015-11-05 16:36
Machine not finishing \"initialization\".It has the old small screen \"operator panel\" BRRTGR31-OF.Sequence of events:1- machine main breaker is turned to ON.2- +- fourteen seconds later, there is a glitch to the LEDs switches.3- the \"HOLZMA\" logo is displayed on the small screen.4- operator stay…...
Show More
➡️ Reply
#Holzma by Douglas Gessford on 2020-05-20 22:07
We have a 1998 Holzma HPP 1132 panel saw. We have been told that the positioning module is bad(CPNC8-23). We replace the drive motor and still intermittency.Cannot find a positioning module anywhere. CAn you repair this or locate aa positioning module for this saw? Please call me at 859-497-0058 EXT…...
Show More
➡️ Reply
#Holzma by Randy Peek Markus Cabinets on 2018-10-31 12:43
We have a Holzma hpp350 panel saw and we believe the cylinder that raises the main saw is going bad. We are wondering if these cylinders can be rebuilt or if they need to be replaced, please advise and thank you
➡️ Reply
#Holzma by william rberson on 2013-12-25 03:17
where can I get technical help and manuals for this saw
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.