I have machine namely OCANO, which apply to SMD epoxy attach for chip resistor and capacitor.The problem now is X-axis can\'t move and always vibrating and jamming. Suspected the Driver motor problem, than we look to this driver was branded by Horyu Engineering and also the main board is belong to your brand. FYI, this machine an old version and no such as wiring diagram and spare part reference. so we face a difficulties to do diagnostic on to this board.Perhaps, your site have a reference about this driver and mainboard.the main problem was;1. the X-aixs can\'t move and jamming with vibrating2. The encorder does not representing the exactly home position.I need your advice or is it possible that your service Engineer to come to Batam?Below the machine information,Mechine type/name:OCM-8010Motherboard :HORYU ENG/JAPAN 4019-100AASER.NO. 703K0352Driver board:HORYU ENG/JAPAN 8031D-100SER.NO. 701I0006
If you need your Horyu Engineering unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.
Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.
Show More