Horyu Engineering Service & Repair Forum

i\'ve a broken sugino self center v6 machine and i\'m going to repair it and drive it through computer.i cant find any detil about spindle motor driver(101949D-120) so i\'m stack on this projectso please if some one can send me some details about this it\'ll help me lot.

—> Purchase or Repair:

Reply🗨️Ask a New Question Below❓

• Horyu Engineering → Driver Motor_X axis damage sympton of vibration ↗
• Horyu Engineering → Horyu Engineering Horyo Spindle drive ↗
• Horyu Engineering → Horyu Engineering Horyu Engineering Horyo Spindle drive ↗

Recent 3 Comments

#Horyu Engineering by Malcolm Beamond on 2005-11-22 09:49

Can you help with the repair of a HORYO Spindle drive fitted to a Sugino Machining Centre?Details are:Type CP-ES E Axis No SCur 60A REV VV3 V5Serial No 00ST0006Year 1991Alarm MessageCPUE AlarmCan you supply Connection and Woiring drawings for this unit?Any help would be most appreciated.RegardsMalco…Purchase or Repair: ...Can you help with the repair of a HORYO Spindle drive fitted to a Sugino Machining Centre?Details are:Type CP-ES E Axis No SCur 60A REV VV3 V5Serial No 00ST0006Year 1991Alarm MessageCPUE AlarmCan you supply Connection and Woiring drawings for this unit?Any help would be most appreciated.RegardsMalcolm BeamondELECTRON SERVICES Ltdwww.electronservices.co.uk

—> Purchase or Repair:
Show More

➡️ Reply

#Horyu Engineering by Rafael Sitinjak on 2010-03-25 02:55

I have machine namely OCANO, which apply to SMD epoxy attach for chip resistor and capacitor.The problem now is X-axis can\'t move and always vibrating and jamming. Suspected the Driver motor problem, than we look to this driver was branded by Horyu Engineering and also the main board is belong to y…Purchase or Repair: ...I have machine namely OCANO, which apply to SMD epoxy attach for chip resistor and capacitor.The problem now is X-axis can\'t move and always vibrating and jamming. Suspected the Driver motor problem, than we look to this driver was branded by Horyu Engineering and also the main board is belong to your brand. FYI, this machine an old version and no such as wiring diagram and spare part reference. so we face a difficulties to do diagnostic on to this board.Perhaps, your site have a reference about this driver and mainboard.the main problem was;1. the X-aixs can\'t move and jamming with vibrating2. The encorder does not representing the exactly home position.I need your advice or is it possible that your service Engineer to come to Batam?Below the machine information,Mechine type/name:OCM-8010Motherboard :HORYU ENG/JAPAN 4019-100AASER.NO. 703K0352Driver board:HORYU ENG/JAPAN 8031D-100SER.NO. 701I0006

—> Purchase or Repair:
Show More

➡️ Reply