Inductotherm Service & Repair Forum

Hi, I would like to ask if the Z board can be calibrated? Reasons: 1. Out of tune. 2. Cannot attain full power. 3. Cannot attain 1200hz frequency. 3. ACR over-voltage tripped.Current condition: 1. Power can reach up tp 400kw only. 2. Frequency up to 1000hz only. 3. Turn on time too long (10secs). 4. Initial voltage upon inverter on is 500V (too high).Induction furnace model: VIP powertrak 500 R series.Company: Negros Metal Corp. Murcia road, Alijis, Bacolod City Negros Occidental 6100 Philippines

—> Purchase or Repair: Ticket Image

— Posted by Devin Villacruz on 2012-07-12

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "Inductotherm"

If you need your Inductotherm unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 4 Comments

#Inductotherm by Scot on 2007-03-20 00:00
Inductotherm 804237 circuit board experiencing intermittent power loss, causing disruptions in industrial unit operation. Need immediate assistance for repair.

—> Purchase or Repair:
➡️ Reply
#Inductotherm by Devin Villacruz on 2012-07-12 07:01
Hi, I would like to ask if the Z board can be calibrated? Reasons: 1. Out of tune. 2. Cannot attain full power. 3. Cannot attain 1200hz frequency. 3. ACR over-voltage tripped.Current condition: 1. Power can reach up tp 400kw only. 2. Frequency up to 1000hz only. 3. Turn on time too long (10secs). 4.…Purchase or Repair: Ticket Image...
Show More
➡️ Reply
#Inductotherm by Krock on 2012-03-07 00:00
the Inductotherm 800897 unit went down mid-shift. Need someone to check this out in the morning. Issue unknown. Cheers!

—> Purchase or Repair:
➡️ Reply
#Inductotherm by Scott Tewell on 2008-03-31 19:29
I have a z board that needs repaired. This has a micro-controller on it. Have you done these in the past?

—> Purchase or Repair:
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.