Inductotherm Service & Repair Forum

Hi, I would like to ask if the Z board can be calibrated? Reasons: 1. Out of tune. 2. Cannot attain full power. 3. Cannot attain 1200hz frequency. 3. ACR over-voltage tripped.Current condition: 1. Power can reach up tp 400kw only. 2. Frequency up to 1000hz only. 3. Turn on time too long (10secs). 4. Initial voltage upon inverter on is 500V (too high).Induction furnace model: VIP powertrak 500 R series.Company: Negros Metal Corp. Murcia road, Alijis, Bacolod City Negros Occidental 6100 Philippines

—> Purchase or Repair:

Reply🗨️Ask a New Question Below❓

• Inductotherm → Inductotherm 800897 ↗
• Inductotherm → Inductotherm 804237 ↗
• Inductotherm → Z board calibration ↗
• Inductotherm → Inductotherm Inductotherm Z board ↗

Recent 4 Comments

#Inductotherm by Devin Villacruz on 2012-07-12 07:01

Hi, I would like to ask if the Z board can be calibrated? Reasons: 1. Out of tune. 2. Cannot attain full power. 3. Cannot attain 1200hz frequency. 3. ACR over-voltage tripped.Current condition: 1. Power can reach up tp 400kw only. 2. Frequency up to 1000hz only. 3. Turn on time too long (10secs). 4.…Purchase or Repair: ...Hi, I would like to ask if the Z board can be calibrated? Reasons: 1. Out of tune. 2. Cannot attain full power. 3. Cannot attain 1200hz frequency. 3. ACR over-voltage tripped.Current condition: 1. Power can reach up tp 400kw only. 2. Frequency up to 1000hz only. 3. Turn on time too long (10secs). 4. Initial voltage upon inverter on is 500V (too high).Induction furnace model: VIP powertrak 500 R series.Company: Negros Metal Corp. Murcia road, Alijis, Bacolod City Negros Occidental 6100 Philippines

—> Purchase or Repair:
Show More

➡️ Reply