Industrial Electronics Repair Service & Repair Forum

Hi, Im getting a E-3 error. I found a manual with an AL-3 Overheating of regenerative resistance but no E-3 specifically. we had a spare drive and i swapped it out and entered all of the parameters, and I get the same error code. Any help or information would be great. Thanks, Jake

—> Purchase or Repair:

Reply🗨️Ask a New Question Below❓

• Industrial Electronics Repair → Industrial Electronics Repair ↗
• Industrial Electronics Repair → Say It Like Never Before ↗
• Industrial Electronics Repair → General Inquiry ↗
• Industrial Electronics Repair → virtualcot Vom ↗
• Industrial Electronics Repair → VigoServo ARS135-025 SN# 900022 ↗
• Industrial Electronics Repair → carrier air conditioner model ↗

Recent 7 Comments

#Industrial Electronics Repair by Sales Service on 2005-05-09 01:42

If you need your unit tested or repaired then give us a call.We offer fair estimates and offer extended warranties.You can contact us at 1-(336)-969-0110Shipping/ReceivingIndustrial Electronic Repair931-E S. Main St #204,Kernersville, NC 27284 Phone: (336) 969-0110We repair industrial electronic dev…Purchase or Repair: ...If you need your unit tested or repaired then give us a call.We offer fair estimates and offer extended warranties.You can contact us at 1-(336)-969-0110Shipping/ReceivingIndustrial Electronic Repair931-E S. Main St #204,Kernersville, NC 27284 Phone: (336) 969-0110We repair industrial electronic devicesIf you have an industrial electronic device that needs repair,Feel free to contact us!

—> Purchase or Repair:
Show More

➡️ Reply

#Industrial Electronics Repair by Jacob Hinz on 2025-07-24 13:42

Hi, Im getting a E-3 error. I found a manual with an AL-3 Overheating of regenerative resistance but no E-3 specifically. we had a spare drive and i swapped it out and entered all of the parameters, and I get the same error code. Any help or information would be great. Thanks, Jake—> …Purchase or Repair: ...Hi, Im getting a E-3 error. I found a manual with an AL-3 Overheating of regenerative resistance but no E-3 specifically. we had a spare drive and i swapped it out and entered all of the parameters, and I get the same error code. Any help or information would be great. Thanks, Jake

—> Purchase or Repair:
Show More

➡️ Reply

#Industrial Electronics Repair by Francisco on 2024-12-05 22:13

I have 2 Goring-Kerr (Thermo Fischer Scientific) DSP2 metal detectors that show the following faults in the status page: Faults: 3 Product memory - search head - RF board. I do not have the operator/supervisor/Engineer passwords and the password seed numbers are (what I assume is by default): Operat…Purchase or Repair: ...I have 2 Goring-Kerr (Thermo Fischer Scientific) DSP2 metal detectors that show the following faults in the status page: Faults: 3 Product memory - search head - RF board. I do not have the operator/supervisor/Engineer passwords and the password seed numbers are (what I assume is by default): Operator: 12345678 Supervisor:23456781 Engineer: 34567812. I have tried using password ZBZB but it does not work. Conveyor belt turns on and off and red fault light is on. Any suggestions? Thanks in advance.

—> Purchase or Repair:
Show More

➡️ Reply