K.E.W Service & Repair Forum

I am trying to refurbish a kew 1502v-66 power washer. I cannot get the oil fired burner to kick on. The control panel has a digital temp gauge and it shows the temperature of the water at its maximum value when the water is cold. I am in question if this is the problem with the burner not firing. I am interested in any electrical diagrams, service manuals, or tech suggestions that you have. Thanks, Josh.

— Posted by Josh Campbell on 2005-10-26

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "K.E.W"

If you need your K.E.W unit tested or repaired,
give us a call at 1-336-969-0110.
We offer free estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 95 Comments

#K.E.W by Bob Schultz III on 2011-08-17 15:47
I need a service manual with part numbers and specifacation please.
➡️ Reply
#K.E.W by J.den Dekker on 2011-04-03 06:34
Geachte meneer/mevrouw,Ik heb heb kew 1500 hogedruk spuitpart nr. 6137219 Serial nr. 6998760.Kunt u mij vertellen of ik een terrascleaner kan krijgen voor deze hogedruk spuit en als dat mogelijk is kunt u mij vertellen waar en wat hij kost.vr.gr.J.den Dekker
➡️ Reply
#K.E.W by mark on 2014-10-21 13:50
hi could you tell me where I would get service manual for kew 1640hathanks mark
➡️ Reply
#K.E.W by mark on 2008-07-06 07:56
clean out the disel jet, clean out fillter under the fan, make sure u have good tight flexi hose connection, good luck
➡️ Reply
#K.E.W by marcondes on 2010-03-17 22:11
my machine stop work hot water and pressure no good work
➡️ Reply
#K.E.W by David Kerr on 2009-06-12 19:28
Hi, Help please, i\'m in need of a new lance for my older Kew Hobby 2600, would you have this item in stock ?
➡️ Reply
#K.E.W by ryan on 2011-04-02 17:51
I have a 1979 kew power washer and am looking for some pump parts or info on where to get parts it is mostly all in good shape put the pump needs work any info would be greatly apresated thanks ryan
➡️ Reply
#K.E.W by gary case on 2010-09-23 15:00
we can\'t get water flow through the machine
➡️ Reply
#K.E.W by Amin on 2011-12-28 06:46
I have Kew 1640h i need operating manual,
➡️ Reply
#K.E.W by William Knee on 2009-03-21 12:25
HI I check all and no start and I am a Electrician
➡️ Reply
#K.E.W by Blair on 2007-08-15 01:10
call windy city equipment located in Elgin, Illinois
➡️ Reply
#K.E.W by Garry S James on 2009-04-09 10:26
I have a KEW 1502V – Hot & Cold Pressure Washer. I will be running this of a Generator at the same time as a water pump which has a rating of 700w.1. Can you what is the start up current of the Pressure Washer.2. What size Generator should I be looking for to run the Pressure Water and the Water Pum…...
Show More
➡️ Reply
#K.E.W by Rudy Martens on 2009-10-28 06:19
I need a operation manual for KEW 1502v-66
➡️ Reply
#K.E.W by steve oliveros on 2011-06-24 22:12
i need a parts list so i could repair the pump
➡️ Reply
#K.E.W by EdwardKn on 2015-03-27 17:20
Hello. And Bye.
➡️ Reply
#K.E.W by AUSTIN GIBBONS on 2010-03-30 14:40
CAN I BUY A SPARE PART FOR THE ABOVE, IE, THE PRESSURE WASHER AT THE END OF THE LANCE.?WITH THANKS AUSTIN GIBBONS
➡️ Reply
#K.E.W by maria helena on 2010-03-17 22:12
i need manual for kew 1640ha
➡️ Reply
#K.E.W by Clifford Brown on 2010-10-10 03:46
I still do not have all the details of what this machine is, but it appears to be a hot water pressure washer.. Would be interested in the instructions manual to see if I can get it going. Do not have all of the ID place numbers copied down yet though. The copper windings for the boiler look good fr…...
Show More
➡️ Reply
#K.E.W by Ruth Montefiore on 2010-03-15 13:33
The black hose pipe connected to this pressure washer has a whole in it. Can it be repaired and if so how please. If not how much will it cost to desptach a replacement to me or where can I purchase this hose pipe? Is it something I can obtain from a builders merchants and if so what size please?I l…...
Show More
➡️ Reply
#K.E.W by gary appleton on 2008-06-10 15:53
i need new hose
➡️ Reply
#K.E.W by mohammed zaki on 2015-03-30 11:01
HelloPlease can you inform me where i can repair my washing machinemodel (5203k) in united arab emitares.Thanks @ Best Regards
➡️ Reply
#K.E.W by ken Tucker on 2008-05-01 16:53
My KEW 1502v-66 is smoking badly and does not get hot. I think the diesel is not burning right. There is a blue flame between the contacts.
➡️ Reply
#K.E.W by frank welch on 2010-12-02 13:46
just want to know how old this machine is and if it can still be repaired,i have no knowledge of what year it was made and know of no place to get it repaired
➡️ Reply
#K.E.W by Hassan. Mortazavi on 2010-10-10 01:05
How do i test the electrod or egniter to see its good?Thanks
➡️ Reply
#K.E.W by Ulf Dahl on 2015-03-24 13:14
HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks!Uffe
➡️ Reply
#K.E.W by PAUL GALLAGHER on 2008-11-17 21:50
HI,I HAVE JUST PURCHASED A KEW 38A2VA POWER WASHER. IS IT POSSIBLE TO GET A MANUAL FOR THIS MACHINE? ALSO WHAT GOES IN THE TANK MARKED WITH A SNOWFLAKE?THANKS PAUL.
➡️ Reply
#K.E.W by Adrian Frost on 2011-05-16 11:17
Hi, I have a KEW Steam Cleaner model 16A2V-66 Year 1986. I bought it from a company asset auction and never saw it working. I have now tried to use it and the temperature lights reached the temperature set once, then the burner went out and would not re-light. I dissconnected the fuel supply to the …...
Show More
➡️ Reply
#K.E.W by steve oiveros on 2011-06-20 23:33
I need a parts schematic so I could repair the pump I need the seals kit.
➡️ Reply
#K.E.W by Owen Torgerson on 2012-03-22 19:12
Great machine, had since new, recently experiencing difficulties acquiring heat.Lots of kerosene, lots of pressure on cold, new fuel spray nozzle...Help
➡️ Reply
#K.E.W by Richard Lane on 2008-12-24 11:32
HelloI have a kew 1502 steam cleaner which has a problem with the burner. It will run for about 5 seconds then cut out, I have changed the diesel filter and cleaned the filter into the nozzle. Also I have checked that the electrodes are working properly. Its as if something is turning the diesel sup…...
Show More
➡️ Reply
#K.E.W by john farkas on 2011-10-26 18:47
For any KEW products call Chris Gerber in S.C. (877)322-2586. Very knowledgable and helpfull. He is the US service rep.
➡️ Reply
#K.E.W by Ola Wikstrand on 2009-11-01 17:38
HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks! Ola
➡️ Reply
#K.E.W by Dale on 2009-04-08 00:10
Hi, put a oring kit in pump an still get only tap pressure everything looks good ,keyway on pump motor fine. any ideas. Thanks,
➡️ Reply
#K.E.W by larry on 2009-03-26 07:25
need to find out how to change the unit from 110 volts to 220 volts. thanks
➡️ Reply
#K.E.W by Anthony blair rowland on 2012-06-04 19:58
Please can you help i have a kew 1502v it will run fine cold, as soon as i demand heat it runs for 5 seconds and switches off if you switch it on & off,it runs for 5seconds and it will do this all day. what is the solution please
➡️ Reply
#K.E.W by MARK on 2010-01-02 19:00
My kew steam cleaner does not have water pressure. It exits the gun but only trickles out. Can you help? Many thanksMark
➡️ Reply
#K.E.W by angelineadlecraft@gmail.com on 2019-05-02 14:02
Good dayI am trying to find a manual to assist me with the heating system of a K.E.W. 38A2VA.Many thanks
➡️ Reply
#K.E.W by Hassan Mortazavi on 2010-10-08 16:23
i just got a used ke w scorpian steam cleaner and everything works exept it does not ignite or no spark to get flame.any idea.thankshassan
➡️ Reply
#K.E.W by thomas thorn on 2009-05-03 09:24
The temprature regulator on the top of the washer is broken off next to the gauge i need a new part
➡️ Reply
#K.E.W by Jeff Osborn on 2009-11-23 21:46
I have recently acquired a K.E.W. Pressure washer and am trying to find information about it. It appears to be from Denmark and in the Model box it just says Hobby. Another box on the ID plate says 62 bar. The gauge on the machine reads 0 to 150 and on the face of the dial it says X 1000. THAT WOULD…...
Show More
➡️ Reply
#K.E.W by Arvid Hartsuiker on 2008-11-11 18:15
Front seal on pump leaking, looking for parts to repair and repair manual. Please give me a call or email. Thanks Arvid
➡️ Reply
#K.E.W by Brent C. on 2012-10-02 22:26
No fuel getting to burner, need manual for test procedure. Thank you, Brent C.
➡️ Reply
#K.E.W by john farkas on 2011-10-26 18:38
I am looking a the circuit board for my 0840HA hot water pressure washer. Mine burned out, the rest of the machine is nearly new. It would be a shame to trash it. KEW no longer makes this board.
➡️ Reply
#K.E.W by Bodengien on 2017-12-18 08:27
HelloBought a secand hand KEW38A2VA and overhauld and cleanend the machine. The boiler doesnt start however. Can I get a manual for the machine ?? Thanks in advance. Bodengien.
➡️ Reply
#K.E.W by Tom Hamilton on 2009-12-16 22:16
I may have the same pressure washer you have. My pressure gauge shows two circular pressure scales. The outer scale is from 0 to 150 with a heavy mark at the 50 digit and 100 digit. At the bottom it says \"BAR\". If your information plate says 62 BAR as mine does then acceptable pressure is between …...
Show More
➡️ Reply
#K.E.W by ken williams on 2011-11-08 03:02
Hi would you have a service manual for this cleaner??
➡️ Reply
#K.E.W by Antonio Gonzalez on 2012-06-19 13:41
need the service manual of KEW 01K pressure washer
➡️ Reply
#K.E.W by Carolyn S. Valdivia on 2011-06-22 21:16
KEW 3803V-103 fuel pump is not delivering to the burner. Please either send a manual or advise. I will call for technical assistance 6/23/2011Thank you Carolyn S. ValdiviaJackson Drop Storage YardTruck & Trailer Repair517-795-1353
➡️ Reply
#K.E.W by Kevin Gonneau on 2007-05-07 19:40
Looking for parts manual of help with parts for Unit Model #3803V-103 1985/40No.# 2104067 240v/1/30 ampAny help would be greatly appreciated.
➡️ Reply
#K.E.W by sandy stevens on 2009-09-28 13:03
Is there anyway to get a takedown of the pump on my kew steam cleaner the model # 08022-56? A parts book would be good.
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.