Troubleshooting K.E.W: Common problems and repair info

K.E.W for Service call 1-336-969-0110 at Industrial Electronics Repair

K.E.W Service & Repair Forum

The temprature regulator on the top of the washer is broken off next to the gauge i need a new part

— Posted by thomas thorn on 2009-05-03

Reply🗨️Ask a New Question Below❓

Recent 95 Comments

#K.E.W by larry on 2009-03-26 07:25

need to find out how to change the unit from 110 volts to 220 volts. thanks

➡️ Reply

#K.E.W by Dale on 2009-04-08 00:10

Hi, put a oring kit in pump an still get only tap pressure everything looks good ,keyway on pump motor fine. any ideas. Thanks,

➡️ Reply

#K.E.W by Carolyn S. Valdivia on 2011-06-22 21:16

KEW 3803V-103 fuel pump is not delivering to the burner. Please either send a manual or advise. I will call for technical assistance 6/23/2011Thank you Carolyn S. ValdiviaJackson Drop Storage YardTruck & Trailer Repair517-795-1353

➡️ Reply

#K.E.W by thomas thorn on 2009-05-03 09:24

The temprature regulator on the top of the washer is broken off next to the gauge i need a new part

➡️ Reply

#K.E.W by mark on 2008-07-06 07:56

clean out the disel jet, clean out fillter under the fan, make sure u have good tight flexi hose connection, good luck

➡️ Reply

#K.E.W by steve oiveros on 2011-06-20 23:33

I need a parts schematic so I could repair the pump I need the seals kit.

➡️ Reply

#K.E.W by Bob Schultz III on 2011-08-17 15:47

I need a service manual with part numbers and specifacation please.

➡️ Reply

#K.E.W by JAMES FARMER on 2016-05-02 19:22

the fuel will not pump, I don`t have the voltage coming out of the oil area of the board to open the solenoid on the fuel pump. I need a schematic to trace the problem, is there one available ?

➡️ Reply

#K.E.W by maria helena on 2010-03-17 22:12

i need manual for kew 1640ha

➡️ Reply

#K.E.W by ken williams on 2011-11-08 03:02

Hi would you have a service manual for this cleaner??

➡️ Reply

#K.E.W by ali on 2009-05-31 05:45

I\'m looking for the maintenance manual for this machine

➡️ Reply

#K.E.W by mark on 2014-10-21 13:50

hi could you tell me where I would get service manual for kew 1640hathanks mark

➡️ Reply

#K.E.W by Grant Neeley on 2012-01-24 13:44

I have a KEW 23A2V pressure washer that the boiler Coil is completely shot now. I have welded some hole back together, but now it is beyond repair. Does anyone know where I can get a replacement coil?

➡️ Reply

#K.E.W by SHABAN LIMANI on 2010-03-01 19:16

guten abent icsh bin ljimani cshaban aus macedonia tetovo icsh brauche eine pumpe for choch druck for kew 1502und kene cshiken in macedonia und kenen preis ceigen bite und in duetsh ich veis bite und in meine email cshriben bite filen dank fur das

➡️ Reply

#K.E.W by dan lucas on 2013-03-13 22:08

hi i brought this k.e.w h1500 steam cleaner some year ago,i put it away after it was working ok over 12month ago.i lent it to my brother and it will not pressure up.....his any one out there i can ring to get parts so i can fix it thx 07779666678

➡️ Reply

#K.E.W by Clifford Brown on 2010-10-10 03:46

I still do not have all the details of what this machine is, but it appears to be a hot water pressure washer.. Would be interested in the instructions manual to see if I can get it going. Do not have all of the ID place numbers copied down yet though. The copper windings for the boiler look good fr…...
Show More

➡️ Reply

#K.E.W by Arvid Hartsuiker on 2008-11-11 18:15

Front seal on pump leaking, looking for parts to repair and repair manual. Please give me a call or email. Thanks Arvid

➡️ Reply

#K.E.W by Ruth Montefiore on 2010-03-15 13:33

The black hose pipe connected to this pressure washer has a whole in it. Can it be repaired and if so how please. If not how much will it cost to desptach a replacement to me or where can I purchase this hose pipe? Is it something I can obtain from a builders merchants and if so what size please?I l…...
Show More

➡️ Reply

#K.E.W by Martin Ferguson on 2009-07-10 14:10

No comments

➡️ Reply

#K.E.W by REYGAN on 2008-11-06 11:58

my steam cleaner 1640h is showing alarm F1 could anybody help me to find out the reason or send me manual of this machine thanksreygan bernard

➡️ Reply

#K.E.W by swordcrown sevices on 2008-08-02 22:17

we have a KEW steam cleaner,not sure of age,trolley mounted, recent purchase, but not working.is there anybody out there who can help us, with regards to diagrams, or any possible imformation, perhaps we can then decide on further age, model etc , your help would be greatly appreciated.Yours sincere…...
Show More

➡️ Reply

#K.E.W by gary case on 2010-09-23 15:00

we can\'t get water flow through the machine

➡️ Reply

#K.E.W by CESAR ALCAZAR on 2011-04-18 14:09

Hi I have a Heated Pressure Washer, and Im lookin for a specific part can you tell me if ispossible to found it. Lelow information of the machineMAKER: KEWMODELL: 3803V-103SER:2103205ASSET:43-1-5

➡️ Reply

#K.E.W by MARK on 2010-01-02 19:00

My kew steam cleaner does not have water pressure. It exits the gun but only trickles out. Can you help? Many thanksMark

➡️ Reply

#K.E.W by Kevin Gonneau on 2007-05-07 19:40

Looking for parts manual of help with parts for Unit Model #3803V-103 1985/40No.# 2104067 240v/1/30 ampAny help would be greatly appreciated.

➡️ Reply

#K.E.W by Bodengien on 2017-12-18 08:27

HelloBought a secand hand KEW38A2VA and overhauld and cleanend the machine. The boiler doesnt start however. Can I get a manual for the machine ?? Thanks in advance. Bodengien.

➡️ Reply

#K.E.W by Garry S James on 2009-04-09 10:26

I have a KEW 1502V – Hot & Cold Pressure Washer. I will be running this of a Generator at the same time as a water pump which has a rating of 700w.1. Can you what is the start up current of the Pressure Washer.2. What size Generator should I be looking for to run the Pressure Water and the Water Pum…...
Show More

➡️ Reply

#K.E.W by Josh Campbell on 2005-10-26 14:14

I am trying to refurbish a kew 1502v-66 power washer. I cannot get the oil fired burner to kick on. The control panel has a digital temp gauge and it shows the temperature of the water at its maximum value when the water is cold. I am in question if this is the problem with the burner not firing. I …...
Show More

➡️ Reply

#K.E.W by Ron on 2010-10-12 02:52

My coil froze last winer when heater broke in shop over weekend , do you have any coils

➡️ Reply

#K.E.W by Blair on 2007-08-15 01:10

call windy city equipment located in Elgin, Illinois

➡️ Reply

#K.E.W by john farkas on 2011-10-26 18:47

For any KEW products call Chris Gerber in S.C. (877)322-2586. Very knowledgable and helpfull. He is the US service rep.

➡️ Reply

#K.E.W by Hassan Mortazavi on 2010-10-08 16:23

i just got a used ke w scorpian steam cleaner and everything works exept it does not ignite or no spark to get flame.any idea.thankshassan

➡️ Reply

#K.E.W by Ulf Dahl on 2015-03-24 13:14

HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks!Uffe

➡️ Reply

#K.E.W by cindy janeski on 2009-05-28 18:35

I am looking for a shop that carries replacement parts for a KEW pressure washer, the hose has sprung a leak and need to replace it the spray nozzle is also attached to the hose as a all in one unit

➡️ Reply

#K.E.W by Tom Hamilton on 2009-12-16 22:16

I may have the same pressure washer you have. My pressure gauge shows two circular pressure scales. The outer scale is from 0 to 150 with a heavy mark at the 50 digit and 100 digit. At the bottom it says \"BAR\". If your information plate says 62 BAR as mine does then acceptable pressure is between …...
Show More

➡️ Reply

#K.E.W by Tim on 2009-09-28 17:42

I am looking for a seal kit for the pump on this unit if you can get one please email me back.

➡️ Reply

#K.E.W by jonas hofer on 2010-03-14 22:44

I need an instruction manual for a KEW 1640H When i put power to it, it just shut\'s off after two seconds, and i have to reset it. A sign in the small screen say\'s, P1 and F1 i don\'t know what they mean.

➡️ Reply

#K.E.W by Hartono on 2011-10-19 06:46

Dear AllPlease give me the information about Services center KEW 0901V In indonesia , for your best cooperation i would to say many thanks

➡️ Reply

#K.E.W by brian breslin on 2009-10-14 19:43

where might I download a user manual for parts and maintenance of my 1640h Thanks Brian

➡️ Reply

#K.E.W by David Kerr on 2009-06-12 19:28

Hi, Help please, i\'m in need of a new lance for my older Kew Hobby 2600, would you have this item in stock ?

➡️ Reply

#K.E.W by Hassan. Mortazavi on 2010-10-10 01:05

How do i test the electrod or egniter to see its good?Thanks

➡️ Reply

#K.E.W by reidar kvalvik on 2010-04-19 13:53

Hi.I need reper manual for KEW royalBest regards Reidar Kvalvik

➡️ Reply

#K.E.W by Gerald Mansfield on 2007-10-01 00:46

I purchased a K.E.W. 1500 unit on a sale and would like to get an owners manual/service manual for it. It\'s an electric unit. Thank you, Gerry Mansfield

➡️ Reply

#K.E.W by Jesus on 2019-10-11 08:59

Hi I have a KEW 1502v and some body stolen parts so I put all back together but for any reason it not working the heater and I suspected it about the wiring position, and the pressure is stopping and not keep spraying and some times work fine but some times not, one time I fix only with a new clamp …...
Show More

➡️ Reply

#K.E.W by hans on 2009-05-13 16:54

i can\'t get pressure on my kew 1640H. But i have seen that there are watercristals in the pressuremeter. Does someone know what the problem is?Thanks

➡️ Reply

#K.E.W by holmeside garage lee scott on 2012-02-13 22:01

i have a kew 1640ha which i am having a bit trouble with reacently when whent to use it it cum up with the fault L1 and now the machine will not start,i was wundering if you could give me a bit help THANKS

➡️ Reply

#K.E.W by sandy stevens on 2009-09-28 13:03

Is there anyway to get a takedown of the pump on my kew steam cleaner the model # 08022-56? A parts book would be good.

➡️ Reply

#K.E.W by Brent C. on 2012-10-02 22:26

No fuel getting to burner, need manual for test procedure. Thank you, Brent C.

➡️ Reply

#K.E.W by mohammed zaki on 2015-03-30 11:01

HelloPlease can you inform me where i can repair my washing machinemodel (5203k) in united arab emitares.Thanks @ Best Regards

➡️ Reply

#K.E.W by leo on 2012-10-14 09:11

DO YOU HAVE A SOLUTION FOR THE OIL VALVE FROM THE BURNERIT WILL NOT GO ON BY WORKING WITH THE MACHINEPRESSION KONTAKTS ARE OKE