K.E.W Service & Repair Forum

I have a copy of the users instruction book for this machine if you are still in need.

β€” Posted by Len on 2009-10-23

ReplyπŸ—¨οΈAsk a New Question Below❓


Recent Comments Search: "K.E.W"

If you need your K.E.W unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110


Recent 95 Comments

#K.E.W by Ruth Montefiore on 2010-03-15 13:33
The black hose pipe connected to this pressure washer has a whole in it. Can it be repaired and if so how please. If not how much will it cost to desptach a replacement to me or where can I purchase this hose pipe? Is it something I can obtain from a builders merchants and if so what size please?I l…...
Show More
#K.E.W by Odyssey Winery on 2010-08-23 21:14
I have a KEW pressure washer, model 0840HA. I am receiving intermittant F2 error codes and C4 error codes. I have taken it into my dealer for \"repair\" however the problem continues. Any ideas?
#K.E.W by Josh Campbell on 2005-10-26 14:14
I am trying to refurbish a kew 1502v-66 power washer. I cannot get the oil fired burner to kick on. The control panel has a digital temp gauge and it shows the temperature of the water at its maximum value when the water is cold. I am in question if this is the problem with the burner not firing. I …...
Show More
#K.E.W by steve oliveros on 2011-06-24 22:12
i need a parts list so i could repair the pump
#K.E.W by Jeff Osborn on 2009-11-23 21:46
I have recently acquired a K.E.W. Pressure washer and am trying to find information about it. It appears to be from Denmark and in the Model box it just says Hobby. Another box on the ID plate says 62 bar. The gauge on the machine reads 0 to 150 and on the face of the dial it says X 1000. THAT WOULD…...
Show More
#K.E.W by thijs thissen on 2009-07-13 08:11
We have recently purchased an second hand KEW high pressure cleaner but it does not get the full cleaning pressure. Can I recieve an owners manual by email to see what parts may be broekn in order to fix the machine?Thank you in advance.best regards,Thijs.
#K.E.W by lyndon hammill on 2006-11-06 19:24
All the lights on the temp gauge lit means that the fuel tankis empty. If there is fuel in the tank, there may not be enoughto activate the tank sensor. put more fuel in.If the tank is full,the tank sender is faulty. It will need replacing.In the meentime you can bypass the tank sender by shorting o…...
Show More
#K.E.W by john farkas on 2011-10-26 18:38
I am looking a the circuit board for my 0840HA hot water pressure washer. Mine burned out, the rest of the machine is nearly new. It would be a shame to trash it. KEW no longer makes this board.
#K.E.W by Ulf Dahl on 2015-03-24 13:14
HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks!Uffe
#K.E.W by leo on 2012-10-14 09:11
DO YOU HAVE A SOLUTION FOR THE OIL VALVE FROM THE BURNERIT WILL NOT GO ON BY WORKING WITH THE MACHINEPRESSION KONTAKTS ARE OKE
#K.E.W by reidar kvalvik on 2010-04-19 13:53
Hi.I need reper manual for KEW royalBest regards Reidar Kvalvik
#K.E.W by mark on 2014-10-21 13:50
hi could you tell me where I would get service manual for kew 1640hathanks mark
#K.E.W by Antonio Gonzalez on 2012-06-19 13:41
need the service manual of KEW 01K pressure washer
#K.E.W by shaban limani on 2011-07-02 17:12
JA ICSH BIN LIMANI CSHABAN ICSH BRAUCHE EINE PUMP MACSHINE FOR AUTO VACSH MACSHINE IST FOR MARKE K.E.W 1502V ICSH CHAP MACSHINE ABER PUMP IST KAPUT BITEIN MAINE EMAIL CSHIKENSI DI VORT FOR MAINE RESPEKT
#K.E.W by mark on 2008-07-06 07:56
clean out the disel jet, clean out fillter under the fan, make sure u have good tight flexi hose connection, good luck
#K.E.W by ali on 2009-05-31 05:45
I\'m looking for the maintenance manual for this machine
#K.E.W by Adrian Frost on 2011-05-16 11:17
Hi, I have a KEW Steam Cleaner model 16A2V-66 Year 1986. I bought it from a company asset auction and never saw it working. I have now tried to use it and the temperature lights reached the temperature set once, then the burner went out and would not re-light. I dissconnected the fuel supply to the …...
Show More
#K.E.W by Raymond Cooper on 2007-12-19 04:18
I need a service manual for a KEW 4503KB with exploded views, parts lists with prices... thank you for your time and help with this problem..Raymond Cooper951-926-5394
#K.E.W by marcondes on 2010-03-17 22:11
my machine stop work hot water and pressure no good work
#K.E.W by Brent C. on 2012-10-02 22:26
No fuel getting to burner, need manual for test procedure. Thank you, Brent C.
#K.E.W by CESAR ALCAZAR on 2011-04-18 14:09
Hi I have a Heated Pressure Washer, and Im lookin for a specific part can you tell me if ispossible to found it. Lelow information of the machineMAKER: KEWMODELL: 3803V-103SER:2103205ASSET:43-1-5
#K.E.W by Ola Wikstrand on 2009-11-01 17:38
HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks! Ola
#K.E.W by Owen Torgerson on 2012-03-22 19:12
Great machine, had since new, recently experiencing difficulties acquiring heat.Lots of kerosene, lots of pressure on cold, new fuel spray nozzle...Help
#K.E.W by Tom Duclos on 2016-05-31 14:22
Need transformer for above unit part number #3819901 can you help me..
#K.E.W by hans on 2009-05-13 16:54
i can\'t get pressure on my kew 1640H. But i have seen that there are watercristals in the pressuremeter. Does someone know what the problem is?Thanks
#K.E.W by Jesus on 2019-10-11 08:59
Hi I have a KEW 1502v and some body stolen parts so I put all back together but for any reason it not working the heater and I suspected it about the wiring position, and the pressure is stopping and not keep spraying and some times work fine but some times not, one time I fix only with a new clamp …...
Show More
#K.E.W by Hassan. Mortazavi on 2010-10-10 01:05
How do i test the electrod or egniter to see its good?Thanks
#K.E.W by thomas thorn on 2009-05-03 09:24
The temprature regulator on the top of the washer is broken off next to the gauge i need a new part
#K.E.W by Joe Duran on 2008-06-13 23:41
Can I find a manual ?I was given one of these to me by a customer. I think I need a special water hose??
#K.E.W by Tom Hamilton on 2009-12-16 22:16
I may have the same pressure washer you have. My pressure gauge shows two circular pressure scales. The outer scale is from 0 to 150 with a heavy mark at the 50 digit and 100 digit. At the bottom it says \"BAR\". If your information plate says 62 BAR as mine does then acceptable pressure is between …...
Show More
#K.E.W by William Knee on 2009-03-21 12:25
HI I check all and no start and I am a Electrician
#K.E.W by MARK on 2010-01-02 19:00
My kew steam cleaner does not have water pressure. It exits the gun but only trickles out. Can you help? Many thanksMark
#K.E.W by Scott A Wilson I on 2012-07-24 12:43
Hi there.I have A Kew steam cleaner model #0802v-56 And would like to see about getting these manual\'s for this cleaner . Please and thank you . Scott
#K.E.W by J.den Dekker on 2011-04-03 06:34
Geachte meneer/mevrouw,Ik heb heb kew 1500 hogedruk spuitpart nr. 6137219 Serial nr. 6998760.Kunt u mij vertellen of ik een terrascleaner kan krijgen voor deze hogedruk spuit en als dat mogelijk is kunt u mij vertellen waar en wat hij kost.vr.gr.J.den Dekker
#K.E.W by SHABAN LIMANI on 2010-03-01 19:16
guten abent icsh bin ljimani cshaban aus macedonia tetovo icsh brauche eine pumpe for choch druck for kew 1502und kene cshiken in macedonia und kenen preis ceigen bite und in duetsh ich veis bite und in meine email cshriben bite filen dank fur das
#K.E.W by Richard Beck on 2009-05-25 21:04
Have a Kew 3803V pressure washer, need to know where I can get itrepaired nearby.thank you
#K.E.W by jonas hofer on 2010-03-14 22:44
I need an instruction manual for a KEW 1640H When i put power to it, it just shut\'s off after two seconds, and i have to reset it. A sign in the small screen say\'s, P1 and F1 i don\'t know what they mean.
#K.E.W by gary appleton on 2008-06-10 15:53
i need new hose
#K.E.W by JAMES FARMER on 2016-05-02 19:22
the fuel will not pump, I don`t have the voltage coming out of the oil area of the board to open the solenoid on the fuel pump. I need a schematic to trace the problem, is there one available ?
#K.E.W by Stuart on 2008-08-09 08:20
I need a service manual for a KEW 1502-66 with exploded views, parts lists with prices... thank you for your time and help with this problem..
#K.E.W by dan johnson on 2007-05-28 23:54
I am trying to find out any info on this Kew (0802v-56)steam washer. If someone has a manual available, that would be great.
#K.E.W by KEIRON on 2008-04-03 18:18
my steam cleaner is flashing F1 light, does anyone know what this fault is and does anyone have a manuel for this model?many thanks
#K.E.W by Ron on 2010-10-12 02:52
My coil froze last winer when heater broke in shop over weekend , do you have any coils
#K.E.W by dan lucas on 2013-03-13 22:08
hi i brought this k.e.w h1500 steam cleaner some year ago,i put it away after it was working ok over 12month ago.i lent it to my brother and it will not pressure up.....his any one out there i can ring to get parts so i can fix it thx 07779666678
#K.E.W by Clifford Brown on 2010-10-10 03:46
I still do not have all the details of what this machine is, but it appears to be a hot water pressure washer.. Would be interested in the instructions manual to see if I can get it going. Do not have all of the ID place numbers copied down yet though. The copper windings for the boiler look good fr…...
Show More
#K.E.W by Amin on 2011-12-28 06:46
I have Kew 1640h i need operating manual,
#K.E.W by swordcrown sevices on 2008-08-02 22:17
we have a KEW steam cleaner,not sure of age,trolley mounted, recent purchase, but not working.is there anybody out there who can help us, with regards to diagrams, or any possible imformation, perhaps we can then decide on further age, model etc , your help would be greatly appreciated.Yours sincere…...
Show More
#K.E.W by Tim on 2009-09-28 17:42
I am looking for a seal kit for the pump on this unit if you can get one please email me back.
#K.E.W by Blair on 2007-08-15 01:10
call windy city equipment located in Elgin, Illinois
#K.E.W by ken Tucker on 2008-05-01 16:53
My KEW 1502v-66 is smoking badly and does not get hot. I think the diesel is not burning right. There is a blue flame between the contacts.

Contact Us

πŸš‘Shop LocationπŸ› οΈ

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
πŸš‘ Rush repair shipments only β€” no walk-ins.

πŸ“žPhone

1-336-969-0110

πŸ“¦Mailing AddressπŸš›

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
πŸ“¦ Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.