Troubleshooting K.E.W: Common problems and repair info

K.E.W for Service call 1-336-969-0110 at Industrial Electronics Repair

K.E.W Service & Repair Forum

HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks!

— Posted by Serge on 2013-06-13

Reply🗨️Ask a New Question Below❓

Recent 95 Comments

#K.E.W by gary appleton on 2008-06-10 15:53

i need new hose

➡️ Reply

#K.E.W by REYGAN on 2008-11-06 11:58

my steam cleaner 1640h is showing alarm F1 could anybody help me to find out the reason or send me manual of this machine thanksreygan bernard

➡️ Reply

#K.E.W by Richard Beck on 2009-05-25 21:04

Have a Kew 3803V pressure washer, need to know where I can get itrepaired nearby.thank you

➡️ Reply

#K.E.W by angelineadlecraft@gmail.com on 2019-05-02 14:02

Good dayI am trying to find a manual to assist me with the heating system of a K.E.W. 38A2VA.Many thanks

➡️ Reply

#K.E.W by ken williams on 2011-11-08 03:02

Hi would you have a service manual for this cleaner??

➡️ Reply

#K.E.W by mario yasin on 2012-12-04 21:44

i need to fix my pei kew 4503kb pumbe kit and throtecan you fix itthank you

➡️ Reply

#K.E.W by Carolyn S. Valdivia on 2011-06-22 21:16

KEW 3803V-103 fuel pump is not delivering to the burner. Please either send a manual or advise. I will call for technical assistance 6/23/2011Thank you Carolyn S. ValdiviaJackson Drop Storage YardTruck & Trailer Repair517-795-1353

➡️ Reply

#K.E.W by LIMANI on 2010-08-08 21:44

guten abent icsh bin limani cshaban aus macedonia icsh brauche eine tail for meine macshine das chaist pumpe for k.e.w.1502 iat mit drei klipen un federen und kenzi zaigen prais bite

➡️ Reply

#K.E.W by Bob Schultz III on 2011-08-17 15:47

I need a service manual with part numbers and specifacation please.

➡️ Reply

#K.E.W by Brent C. on 2012-10-02 22:26

No fuel getting to burner, need manual for test procedure. Thank you, Brent C.

➡️ Reply

#K.E.W by Ola Wikstrand on 2009-11-01 17:38

HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks! Ola

➡️ Reply

#K.E.W by hans on 2009-05-13 16:54

i can\'t get pressure on my kew 1640H. But i have seen that there are watercristals in the pressuremeter. Does someone know what the problem is?Thanks

➡️ Reply

#K.E.W by Martin Ferguson on 2009-07-10 14:10

No comments

➡️ Reply

#K.E.W by Scott A Wilson I on 2012-07-24 12:43

Hi there.I have A Kew steam cleaner model #0802v-56 And would like to see about getting these manual\'s for this cleaner . Please and thank you . Scott

➡️ Reply

#K.E.W by Hassan. Mortazavi on 2010-10-10 01:05

How do i test the electrod or egniter to see its good?Thanks

➡️ Reply

#K.E.W by AUSTIN GIBBONS on 2010-03-30 14:40

CAN I BUY A SPARE PART FOR THE ABOVE, IE, THE PRESSURE WASHER AT THE END OF THE LANCE.?WITH THANKS AUSTIN GIBBONS

➡️ Reply

#K.E.W by Ron on 2010-10-12 02:52

My coil froze last winer when heater broke in shop over weekend , do you have any coils

➡️ Reply

#K.E.W by JAMES FARMER on 2016-05-02 19:22

the fuel will not pump, I don`t have the voltage coming out of the oil area of the board to open the solenoid on the fuel pump. I need a schematic to trace the problem, is there one available ?

➡️ Reply

#K.E.W by steve oliveros on 2011-06-24 22:12

i need a parts list so i could repair the pump

➡️ Reply

#K.E.W by Antonio Gonzalez on 2012-06-19 13:41

need the service manual of KEW 01K pressure washer

➡️ Reply

#K.E.W by marcondes on 2010-03-17 22:11

my machine stop work hot water and pressure no good work

➡️ Reply

#K.E.W by EdwardKn on 2015-03-27 17:20

Hello. And Bye.

➡️ Reply

#K.E.W by dan lucas on 2013-03-13 22:08

hi i brought this k.e.w h1500 steam cleaner some year ago,i put it away after it was working ok over 12month ago.i lent it to my brother and it will not pressure up.....his any one out there i can ring to get parts so i can fix it thx 07779666678

➡️ Reply

#K.E.W by dan johnson on 2007-05-28 23:54

I am trying to find out any info on this Kew (0802v-56)steam washer. If someone has a manual available, that would be great.

➡️ Reply

#K.E.W by Rudy Martens on 2009-10-28 06:19

I need a operation manual for KEW 1502v-66

➡️ Reply

#K.E.W by lyndon hammill on 2006-11-06 19:24

All the lights on the temp gauge lit means that the fuel tankis empty. If there is fuel in the tank, there may not be enoughto activate the tank sensor. put more fuel in.If the tank is full,the tank sender is faulty. It will need replacing.In the meentime you can bypass the tank sender by shorting o…...
Show More

➡️ Reply

#K.E.W by Bože Gudelj on 2021-01-28 20:56

KEW 1502 V-66 user manual , service manual

➡️ Reply

#K.E.W by brian breslin on 2009-10-14 19:43

where might I download a user manual for parts and maintenance of my 1640h Thanks Brian

➡️ Reply

#K.E.W by ken Tucker on 2008-05-01 16:53

My KEW 1502v-66 is smoking badly and does not get hot. I think the diesel is not burning right. There is a blue flame between the contacts.

➡️ Reply

#K.E.W by Hartono on 2011-10-19 06:46

Dear AllPlease give me the information about Services center KEW 0901V In indonesia , for your best cooperation i would to say many thanks

➡️ Reply

#K.E.W by Bodengien on 2017-12-18 08:27

HelloBought a secand hand KEW38A2VA and overhauld and cleanend the machine. The boiler doesnt start however. Can I get a manual for the machine ?? Thanks in advance. Bodengien.

➡️ Reply

#K.E.W by CESAR ALCAZAR on 2011-04-18 14:09

Hi I have a Heated Pressure Washer, and Im lookin for a specific part can you tell me if ispossible to found it. Lelow information of the machineMAKER: KEWMODELL: 3803V-103SER:2103205ASSET:43-1-5

➡️ Reply

#K.E.W by mark on 2008-07-06 07:56

clean out the disel jet, clean out fillter under the fan, make sure u have good tight flexi hose connection, good luck

➡️ Reply

#K.E.W by Arvid Hartsuiker on 2008-11-11 18:15

Front seal on pump leaking, looking for parts to repair and repair manual. Please give me a call or email. Thanks Arvid

➡️ Reply

#K.E.W by Serge on 2013-06-13 13:06

HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks!

➡️ Reply

#K.E.W by KEIRON on 2008-04-03 18:18

my steam cleaner is flashing F1 light, does anyone know what this fault is and does anyone have a manuel for this model?many thanks

➡️ Reply

#K.E.W by Gary on 2009-06-07 19:47

The burner won\'t turn off can anyone help

➡️ Reply

#K.E.W by Dale on 2009-04-08 00:10

Hi, put a oring kit in pump an still get only tap pressure everything looks good ,keyway on pump motor fine. any ideas. Thanks,

➡️ Reply

#K.E.W by thijs thissen on 2009-07-13 08:11

We have recently purchased an second hand KEW high pressure cleaner but it does not get the full cleaning pressure. Can I recieve an owners manual by email to see what parts may be broekn in order to fix the machine?Thank you in advance.best regards,Thijs.

➡️ Reply

#K.E.W by reidar kvalvik on 2010-04-19 13:53

Hi.I need reper manual for KEW royalBest regards Reidar Kvalvik

➡️ Reply

#K.E.W by gary case on 2010-09-23 15:00

we can\'t get water flow through the machine

➡️ Reply

#K.E.W by Owen Torgerson on 2012-03-22 19:12

Great machine, had since new, recently experiencing difficulties acquiring heat.Lots of kerosene, lots of pressure on cold, new fuel spray nozzle...Help

➡️ Reply

#K.E.W by Garry S James on 2009-04-09 10:26

I have a KEW 1502V – Hot & Cold Pressure Washer. I will be running this of a Generator at the same time as a water pump which has a rating of 700w.1. Can you what is the start up current of the Pressure Washer.2. What size Generator should I be looking for to run the Pressure Water and the Water Pum…...
Show More

➡️ Reply

#K.E.W by ryan on 2011-04-02 17:51

I have a 1979 kew power washer and am looking for some pump parts or info on where to get parts it is mostly all in good shape put the pump needs work any info would be greatly apresated thanks ryan

➡️ Reply

#K.E.W by larry on 2009-03-26 07:25

need to find out how to change the unit from 110 volts to 220 volts. thanks

➡️ Reply

#K.E.W by Josh Campbell on 2005-10-26 14:14

I am trying to refurbish a kew 1502v-66 power washer. I cannot get the oil fired burner to kick on. The control panel has a digital temp gauge and it shows the temperature of the water at its maximum value when the water is cold. I am in question if this is the problem with the burner not firing. I …...
Show More

➡️ Reply

#K.E.W by Ruth Montefiore on 2010-03-15 13:33

The black hose pipe connected to this pressure washer has a whole in it. Can it be repaired and if so how please. If not how much will it cost to desptach a replacement to me or where can I purchase this hose pipe? Is it something I can obtain from a builders merchants and if so what size please?I l…...
Show More

➡️ Reply

#K.E.W by Jesus on 2019-10-11 08:59

Hi I have a KEW 1502v and some body stolen parts so I put all back together but for any reason it not working the heater and I suspected it about the wiring position, and the pressure is stopping and not keep spraying and some times work fine but some times not, one time I fix only with a new clamp …...
Show More

➡️ Reply

#K.E.W by john farkas on 2011-10-26 18:38

I am looking a the circuit board for my 0840HA hot water pressure washer. Mine burned out, the rest of the machine is nearly new. It would be a shame to trash it. KEW no longer makes this board.

➡️ Reply

#K.E.W by TOBY ANDERSON on 2014-08-15 17:47

I have a kew alto 2340ha Everything was working and the usint up and quit It showed a 0 flashing and I unplougged it and put it back it reset to solid 0 but when you push the power on it does nothing. I let sit unplugged but nothing works now. Is there anyone who works on these anymore I am in Wisco…...
Show More

➡️ Reply

K.E.W Service & Repair Forum

Reply🗨️Ask a New Question Below❓

Recent 95 Comments

Contact Us

🚑Shop Location🛠️

📞Phone

📦Mailing Address🚛