Troubleshooting K.E.W: Common problems and repair info

K.E.W for Service call 1-336-969-0110 at Industrial Electronics Repair

K.E.W Service & Repair Forum

my steam cleaner is flashing F1 light, does anyone know what this fault is and does anyone have a manuel for this model?many thanks

— Posted by KEIRON on 2008-04-03

Reply🗨️Ask a New Question Below❓

Recent 95 Comments

#K.E.W by Ola Wikstrand on 2009-11-01 17:38

HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks! Ola

➡️ Reply

#K.E.W by Jesus on 2019-10-11 08:59

Hi I have a KEW 1502v and some body stolen parts so I put all back together but for any reason it not working the heater and I suspected it about the wiring position, and the pressure is stopping and not keep spraying and some times work fine but some times not, one time I fix only with a new clamp …...
Show More

➡️ Reply

#K.E.W by PAUL GALLAGHER on 2008-11-17 21:50

HI,I HAVE JUST PURCHASED A KEW 38A2VA POWER WASHER. IS IT POSSIBLE TO GET A MANUAL FOR THIS MACHINE? ALSO WHAT GOES IN THE TANK MARKED WITH A SNOWFLAKE?THANKS PAUL.

➡️ Reply

#K.E.W by JAMES FARMER on 2016-05-02 19:22

the fuel will not pump, I don`t have the voltage coming out of the oil area of the board to open the solenoid on the fuel pump. I need a schematic to trace the problem, is there one available ?

➡️ Reply

#K.E.W by Arvid Hartsuiker on 2008-11-11 18:15

Front seal on pump leaking, looking for parts to repair and repair manual. Please give me a call or email. Thanks Arvid

➡️ Reply

#K.E.W by Len on 2009-10-23 14:28

I have a copy of the users instruction book for this machine if you are still in need.

➡️ Reply

#K.E.W by gary appleton on 2008-06-10 15:53

i need new hose

➡️ Reply

#K.E.W by Garry S James on 2009-04-09 10:26

I have a KEW 1502V – Hot & Cold Pressure Washer. I will be running this of a Generator at the same time as a water pump which has a rating of 700w.1. Can you what is the start up current of the Pressure Washer.2. What size Generator should I be looking for to run the Pressure Water and the Water Pum…...
Show More

➡️ Reply

#K.E.W by William Knee on 2009-03-21 12:25

HI I check all and no start and I am a Electrician

➡️ Reply

#K.E.W by EdwardKn on 2015-03-27 17:20

Hello. And Bye.

➡️ Reply

#K.E.W by Tim on 2009-09-28 17:42

I am looking for a seal kit for the pump on this unit if you can get one please email me back.

➡️ Reply

#K.E.W by Six B Construction on 2008-10-02 15:28

I need a operation manuel for K.E.W. 3803V-103

➡️ Reply

#K.E.W by Jeff Osborn on 2009-11-23 21:46

I have recently acquired a K.E.W. Pressure washer and am trying to find information about it. It appears to be from Denmark and in the Model box it just says Hobby. Another box on the ID plate says 62 bar. The gauge on the machine reads 0 to 150 and on the face of the dial it says X 1000. THAT WOULD…...
Show More

➡️ Reply

#K.E.W by Adrian Frost on 2011-05-16 11:17

Hi, I have a KEW Steam Cleaner model 16A2V-66 Year 1986. I bought it from a company asset auction and never saw it working. I have now tried to use it and the temperature lights reached the temperature set once, then the burner went out and would not re-light. I dissconnected the fuel supply to the …...
Show More

➡️ Reply

#K.E.W by leo on 2012-10-14 09:11

DO YOU HAVE A SOLUTION FOR THE OIL VALVE FROM THE BURNERIT WILL NOT GO ON BY WORKING WITH THE MACHINEPRESSION KONTAKTS ARE OKE

➡️ Reply

#K.E.W by Amin on 2011-12-28 06:46

I have Kew 1640h i need operating manual,

➡️ Reply

#K.E.W by Tom Duclos on 2016-05-31 14:22

Need transformer for above unit part number #3819901 can you help me..

➡️ Reply

#K.E.W by Kevin Gonneau on 2007-05-07 19:40

Looking for parts manual of help with parts for Unit Model #3803V-103 1985/40No.# 2104067 240v/1/30 ampAny help would be greatly appreciated.

➡️ Reply

#K.E.W by mohammed zaki on 2015-03-30 11:01

HelloPlease can you inform me where i can repair my washing machinemodel (5203k) in united arab emitares.Thanks @ Best Regards

➡️ Reply

#K.E.W by CESAR ALCAZAR on 2011-04-18 14:09

Hi I have a Heated Pressure Washer, and Im lookin for a specific part can you tell me if ispossible to found it. Lelow information of the machineMAKER: KEWMODELL: 3803V-103SER:2103205ASSET:43-1-5

➡️ Reply

#K.E.W by TOBY ANDERSON on 2014-08-15 17:47

I have a kew alto 2340ha Everything was working and the usint up and quit It showed a 0 flashing and I unplougged it and put it back it reset to solid 0 but when you push the power on it does nothing. I let sit unplugged but nothing works now. Is there anyone who works on these anymore I am in Wisco…...
Show More

➡️ Reply

#K.E.W by holmeside garage lee scott on 2012-02-13 22:01

i have a kew 1640ha which i am having a bit trouble with reacently when whent to use it it cum up with the fault L1 and now the machine will not start,i was wundering if you could give me a bit help THANKS

➡️ Reply

#K.E.W by ken williams on 2011-11-08 03:02

Hi would you have a service manual for this cleaner??

➡️ Reply

#K.E.W by Grant Neeley on 2012-01-24 13:44

I have a KEW 23A2V pressure washer that the boiler Coil is completely shot now. I have welded some hole back together, but now it is beyond repair. Does anyone know where I can get a replacement coil?

➡️ Reply

#K.E.W by jonas hofer on 2010-03-14 22:44

I need an instruction manual for a KEW 1640H When i put power to it, it just shut\'s off after two seconds, and i have to reset it. A sign in the small screen say\'s, P1 and F1 i don\'t know what they mean.

➡️ Reply

#K.E.W by Josh Campbell on 2005-10-26 14:14

I am trying to refurbish a kew 1502v-66 power washer. I cannot get the oil fired burner to kick on. The control panel has a digital temp gauge and it shows the temperature of the water at its maximum value when the water is cold. I am in question if this is the problem with the burner not firing. I …...
Show More

➡️ Reply

#K.E.W by mark on 2008-07-06 07:56

clean out the disel jet, clean out fillter under the fan, make sure u have good tight flexi hose connection, good luck

➡️ Reply

#K.E.W by Hassan Mortazavi on 2010-10-08 16:23

i just got a used ke w scorpian steam cleaner and everything works exept it does not ignite or no spark to get flame.any idea.thankshassan

➡️ Reply

#K.E.W by Scott A Wilson I on 2012-07-24 12:43

Hi there.I have A Kew steam cleaner model #0802v-56 And would like to see about getting these manual\'s for this cleaner . Please and thank you . Scott

➡️ Reply

#K.E.W by REYGAN on 2008-11-06 11:58

my steam cleaner 1640h is showing alarm F1 could anybody help me to find out the reason or send me manual of this machine thanksreygan bernard

➡️ Reply

#K.E.W by Bože Gudelj on 2021-01-28 20:56

KEW 1502 V-66 user manual , service manual

➡️ Reply

#K.E.W by Brent C. on 2012-10-02 22:26

No fuel getting to burner, need manual for test procedure. Thank you, Brent C.

➡️ Reply

#K.E.W by sandy stevens on 2009-09-28 13:03

Is there anyway to get a takedown of the pump on my kew steam cleaner the model # 08022-56? A parts book would be good.

➡️ Reply

#K.E.W by Bob Schultz III on 2011-08-17 15:47

I need a service manual with part numbers and specifacation please.

➡️ Reply

#K.E.W by mario yasin on 2012-12-04 21:44

i need to fix my pei kew 4503kb pumbe kit and throtecan you fix itthank you

➡️ Reply

#K.E.W by Clifford Brown on 2010-10-10 03:46

I still do not have all the details of what this machine is, but it appears to be a hot water pressure washer.. Would be interested in the instructions manual to see if I can get it going. Do not have all of the ID place numbers copied down yet though. The copper windings for the boiler look good fr…...
Show More

➡️ Reply

#K.E.W by Hassan. Mortazavi on 2010-10-10 01:05

How do i test the electrod or egniter to see its good?Thanks

➡️ Reply

#K.E.W by Ulf Dahl on 2015-03-24 13:14

HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks!Uffe

➡️ Reply

#K.E.W by Serge on 2013-06-13 13:06

HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks!

➡️ Reply

#K.E.W by dan lucas on 2013-03-13 22:08

hi i brought this k.e.w h1500 steam cleaner some year ago,i put it away after it was working ok over 12month ago.i lent it to my brother and it will not pressure up.....his any one out there i can ring to get parts so i can fix it thx 07779666678

➡️ Reply

#K.E.W by Tom Hamilton on 2009-12-16 22:16

I may have the same pressure washer you have. My pressure gauge shows two circular pressure scales. The outer scale is from 0 to 150 with a heavy mark at the 50 digit and 100 digit. At the bottom it says \"BAR\". If your information plate says 62 BAR as mine does then acceptable pressure is between …...
Show More

➡️ Reply

#K.E.W by ken Tucker on 2008-05-01 16:53

My KEW 1502v-66 is smoking badly and does not get hot. I think the diesel is not burning right. There is a blue flame between the contacts.

➡️ Reply

#K.E.W by Gary on 2009-06-07 19:47

The burner won\'t turn off can anyone help

➡️ Reply

#K.E.W by steve oiveros on 2011-06-20 23:33

I need a parts schematic so I could repair the pump I need the seals kit.

➡️ Reply

#K.E.W by Martin Ferguson on 2009-07-10 14:10

No comments