K.E.W Service & Repair Forum

where might I download a user manual for parts and maintenance of my 1640h Thanks Brian

— Posted by brian breslin on 2009-10-14

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "K.E.W"

If you need your K.E.W unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110

Recent 95 Comments

#K.E.W by john farkas on 2011-10-26 18:38
I am looking a the circuit board for my 0840HA hot water pressure washer. Mine burned out, the rest of the machine is nearly new. It would be a shame to trash it. KEW no longer makes this board.
➡️ Reply
#K.E.W by Martin Ferguson on 2009-07-10 14:10
No comments
➡️ Reply
#K.E.W by swordcrown sevices on 2008-08-02 22:17
we have a KEW steam cleaner,not sure of age,trolley mounted, recent purchase, but not working.is there anybody out there who can help us, with regards to diagrams, or any possible imformation, perhaps we can then decide on further age, model etc , your help would be greatly appreciated.Yours sincere…...
Show More
➡️ Reply
#K.E.W by Carolyn S. Valdivia on 2011-06-22 21:16
KEW 3803V-103 fuel pump is not delivering to the burner. Please either send a manual or advise. I will call for technical assistance 6/23/2011Thank you Carolyn S. ValdiviaJackson Drop Storage YardTruck & Trailer Repair517-795-1353
➡️ Reply
#K.E.W by frank welch on 2010-12-02 13:46
just want to know how old this machine is and if it can still be repaired,i have no knowledge of what year it was made and know of no place to get it repaired
➡️ Reply
#K.E.W by marcondes on 2010-03-17 22:11
my machine stop work hot water and pressure no good work
➡️ Reply
#K.E.W by Bob Schultz III on 2011-08-17 15:47
I need a service manual with part numbers and specifacation please.
➡️ Reply
#K.E.W by Ulf Dahl on 2015-03-24 13:14
HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks!Uffe
➡️ Reply
#K.E.W by MARK on 2010-01-02 19:00
My kew steam cleaner does not have water pressure. It exits the gun but only trickles out. Can you help? Many thanksMark
➡️ Reply
#K.E.W by Josh Campbell on 2005-10-26 14:14
I am trying to refurbish a kew 1502v-66 power washer. I cannot get the oil fired burner to kick on. The control panel has a digital temp gauge and it shows the temperature of the water at its maximum value when the water is cold. I am in question if this is the problem with the burner not firing. I …...
Show More
➡️ Reply
#K.E.W by Serge on 2013-06-13 13:06
HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks!
➡️ Reply
#K.E.W by REYGAN on 2008-11-06 11:58
my steam cleaner 1640h is showing alarm F1 could anybody help me to find out the reason or send me manual of this machine thanksreygan bernard
➡️ Reply
#K.E.W by Hassan. Mortazavi on 2010-10-10 01:05
How do i test the electrod or egniter to see its good?Thanks
➡️ Reply
#K.E.W by mohammed zaki on 2015-03-30 11:01
HelloPlease can you inform me where i can repair my washing machinemodel (5203k) in united arab emitares.Thanks @ Best Regards
➡️ Reply
#K.E.W by mark on 2014-10-21 13:50
hi could you tell me where I would get service manual for kew 1640hathanks mark
➡️ Reply
#K.E.W by William Knee on 2009-03-21 12:25
HI I check all and no start and I am a Electrician
➡️ Reply
#K.E.W by Clifford Brown on 2010-10-10 03:46
I still do not have all the details of what this machine is, but it appears to be a hot water pressure washer.. Would be interested in the instructions manual to see if I can get it going. Do not have all of the ID place numbers copied down yet though. The copper windings for the boiler look good fr…...
Show More
➡️ Reply
#K.E.W by TOBY ANDERSON on 2014-08-15 17:47
I have a kew alto 2340ha Everything was working and the usint up and quit It showed a 0 flashing and I unplougged it and put it back it reset to solid 0 but when you push the power on it does nothing. I let sit unplugged but nothing works now. Is there anyone who works on these anymore I am in Wisco…...
Show More
➡️ Reply
#K.E.W by Anthony blair rowland on 2012-06-04 19:58
Please can you help i have a kew 1502v it will run fine cold, as soon as i demand heat it runs for 5 seconds and switches off if you switch it on & off,it runs for 5seconds and it will do this all day. what is the solution please
➡️ Reply
#K.E.W by Six B Construction on 2008-10-02 15:28
I need a operation manuel for K.E.W. 3803V-103
➡️ Reply
#K.E.W by ken williams on 2011-11-08 03:02
Hi would you have a service manual for this cleaner??
➡️ Reply
#K.E.W by Adrian Frost on 2011-05-16 11:17
Hi, I have a KEW Steam Cleaner model 16A2V-66 Year 1986. I bought it from a company asset auction and never saw it working. I have now tried to use it and the temperature lights reached the temperature set once, then the burner went out and would not re-light. I dissconnected the fuel supply to the …...
Show More
➡️ Reply
#K.E.W by Hartono on 2011-10-19 06:46
Dear AllPlease give me the information about Services center KEW 0901V In indonesia , for your best cooperation i would to say many thanks
➡️ Reply
#K.E.W by Blair on 2007-08-15 01:10
call windy city equipment located in Elgin, Illinois
➡️ Reply
#K.E.W by Owen Torgerson on 2012-03-22 19:12
Great machine, had since new, recently experiencing difficulties acquiring heat.Lots of kerosene, lots of pressure on cold, new fuel spray nozzle...Help
➡️ Reply
#K.E.W by lyndon hammill on 2006-11-06 19:24
All the lights on the temp gauge lit means that the fuel tankis empty. If there is fuel in the tank, there may not be enoughto activate the tank sensor. put more fuel in.If the tank is full,the tank sender is faulty. It will need replacing.In the meentime you can bypass the tank sender by shorting o…...
Show More
➡️ Reply
#K.E.W by larry on 2009-03-26 07:25
need to find out how to change the unit from 110 volts to 220 volts. thanks
➡️ Reply
#K.E.W by maria helena on 2010-03-17 22:12
i need manual for kew 1640ha
➡️ Reply
#K.E.W by thomas thorn on 2009-05-03 09:24
The temprature regulator on the top of the washer is broken off next to the gauge i need a new part
➡️ Reply
#K.E.W by KEIRON on 2008-04-03 18:18
my steam cleaner is flashing F1 light, does anyone know what this fault is and does anyone have a manuel for this model?many thanks
➡️ Reply
#K.E.W by Bodengien on 2017-12-18 08:27
HelloBought a secand hand KEW38A2VA and overhauld and cleanend the machine. The boiler doesnt start however. Can I get a manual for the machine ?? Thanks in advance. Bodengien.
➡️ Reply
#K.E.W by Jeff Osborn on 2009-11-23 21:46
I have recently acquired a K.E.W. Pressure washer and am trying to find information about it. It appears to be from Denmark and in the Model box it just says Hobby. Another box on the ID plate says 62 bar. The gauge on the machine reads 0 to 150 and on the face of the dial it says X 1000. THAT WOULD…...
Show More
➡️ Reply
#K.E.W by leo on 2012-10-14 09:11
DO YOU HAVE A SOLUTION FOR THE OIL VALVE FROM THE BURNERIT WILL NOT GO ON BY WORKING WITH THE MACHINEPRESSION KONTAKTS ARE OKE
➡️ Reply
#K.E.W by Richard Beck on 2009-05-25 21:04
Have a Kew 3803V pressure washer, need to know where I can get itrepaired nearby.thank you
➡️ Reply
#K.E.W by EdwardKn on 2015-03-27 17:20
Hello. And Bye.
➡️ Reply
#K.E.W by Odyssey Winery on 2010-08-23 21:14
I have a KEW pressure washer, model 0840HA. I am receiving intermittant F2 error codes and C4 error codes. I have taken it into my dealer for \"repair\" however the problem continues. Any ideas?
➡️ Reply
#K.E.W by gary appleton on 2008-06-10 15:53
i need new hose
➡️ Reply
#K.E.W by JAMES FARMER on 2016-05-02 19:22
the fuel will not pump, I don`t have the voltage coming out of the oil area of the board to open the solenoid on the fuel pump. I need a schematic to trace the problem, is there one available ?
➡️ Reply
#K.E.W by Stuart on 2008-08-09 08:20
I need a service manual for a KEW 1502-66 with exploded views, parts lists with prices... thank you for your time and help with this problem..
➡️ Reply
#K.E.W by holmeside garage lee scott on 2012-02-13 22:01
i have a kew 1640ha which i am having a bit trouble with reacently when whent to use it it cum up with the fault L1 and now the machine will not start,i was wundering if you could give me a bit help THANKS
➡️ Reply
#K.E.W by AUSTIN GIBBONS on 2010-03-30 14:40
CAN I BUY A SPARE PART FOR THE ABOVE, IE, THE PRESSURE WASHER AT THE END OF THE LANCE.?WITH THANKS AUSTIN GIBBONS
➡️ Reply
#K.E.W by CESAR ALCAZAR on 2011-04-18 14:09
Hi I have a Heated Pressure Washer, and Im lookin for a specific part can you tell me if ispossible to found it. Lelow information of the machineMAKER: KEWMODELL: 3803V-103SER:2103205ASSET:43-1-5
➡️ Reply
#K.E.W by ryan on 2011-04-02 17:51
I have a 1979 kew power washer and am looking for some pump parts or info on where to get parts it is mostly all in good shape put the pump needs work any info would be greatly apresated thanks ryan
➡️ Reply
#K.E.W by SHABAN LIMANI on 2010-03-01 19:16
guten abent icsh bin ljimani cshaban aus macedonia tetovo icsh brauche eine pumpe for choch druck for kew 1502und kene cshiken in macedonia und kenen preis ceigen bite und in duetsh ich veis bite und in meine email cshriben bite filen dank fur das
➡️ Reply
#K.E.W by m j cars on 2011-03-17 11:08
when i turn the machine on it trips the electrick
➡️ Reply
#K.E.W by Joe Duran on 2008-06-13 23:41
Can I find a manual ?I was given one of these to me by a customer. I think I need a special water hose??
➡️ Reply
#K.E.W by steve oiveros on 2011-06-20 23:33
I need a parts schematic so I could repair the pump I need the seals kit.
➡️ Reply
#K.E.W by PAUL GALLAGHER on 2008-11-17 21:50
HI,I HAVE JUST PURCHASED A KEW 38A2VA POWER WASHER. IS IT POSSIBLE TO GET A MANUAL FOR THIS MACHINE? ALSO WHAT GOES IN THE TANK MARKED WITH A SNOWFLAKE?THANKS PAUL.
➡️ Reply
#K.E.W by Scott A Wilson I on 2012-07-24 12:43
Hi there.I have A Kew steam cleaner model #0802v-56 And would like to see about getting these manual\'s for this cleaner . Please and thank you . Scott
➡️ Reply
#K.E.W by Amin on 2011-12-28 06:46
I have Kew 1640h i need operating manual,
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.