K.E.W Service & Repair Forum

My kew steam cleaner does not have water pressure. It exits the gun but only trickles out. Can you help? Many thanksMark

— Posted by MARK on 2010-01-02

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "K.E.W"

If you need your K.E.W unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110

Recent 95 Comments

#K.E.W by KEIRON on 2008-04-03 18:18
my steam cleaner is flashing F1 light, does anyone know what this fault is and does anyone have a manuel for this model?many thanks
➡️ Reply
#K.E.W by Richard Beck on 2009-05-25 21:04
Have a Kew 3803V pressure washer, need to know where I can get itrepaired nearby.thank you
➡️ Reply
#K.E.W by Garry S James on 2009-04-09 10:26
I have a KEW 1502V – Hot & Cold Pressure Washer. I will be running this of a Generator at the same time as a water pump which has a rating of 700w.1. Can you what is the start up current of the Pressure Washer.2. What size Generator should I be looking for to run the Pressure Water and the Water Pum…...
Show More
➡️ Reply
#K.E.W by dan lucas on 2013-03-13 22:08
hi i brought this k.e.w h1500 steam cleaner some year ago,i put it away after it was working ok over 12month ago.i lent it to my brother and it will not pressure up.....his any one out there i can ring to get parts so i can fix it thx 07779666678
➡️ Reply
#K.E.W by Ola Wikstrand on 2009-11-01 17:38
HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks! Ola
➡️ Reply
#K.E.W by JAMES FARMER on 2016-05-02 19:22
the fuel will not pump, I don`t have the voltage coming out of the oil area of the board to open the solenoid on the fuel pump. I need a schematic to trace the problem, is there one available ?
➡️ Reply
#K.E.W by AUSTIN GIBBONS on 2010-03-30 14:40
CAN I BUY A SPARE PART FOR THE ABOVE, IE, THE PRESSURE WASHER AT THE END OF THE LANCE.?WITH THANKS AUSTIN GIBBONS
➡️ Reply
#K.E.W by marcondes on 2010-03-17 22:11
my machine stop work hot water and pressure no good work
➡️ Reply
#K.E.W by maria helena on 2010-03-17 22:12
i need manual for kew 1640ha
➡️ Reply
#K.E.W by Carolyn S. Valdivia on 2011-06-22 21:16
KEW 3803V-103 fuel pump is not delivering to the burner. Please either send a manual or advise. I will call for technical assistance 6/23/2011Thank you Carolyn S. ValdiviaJackson Drop Storage YardTruck & Trailer Repair517-795-1353
➡️ Reply
#K.E.W by Six B Construction on 2008-10-02 15:28
I need a operation manuel for K.E.W. 3803V-103
➡️ Reply
#K.E.W by Owen Torgerson on 2012-03-22 19:12
Great machine, had since new, recently experiencing difficulties acquiring heat.Lots of kerosene, lots of pressure on cold, new fuel spray nozzle...Help
➡️ Reply
#K.E.W by Bodengien on 2017-12-18 08:27
HelloBought a secand hand KEW38A2VA and overhauld and cleanend the machine. The boiler doesnt start however. Can I get a manual for the machine ?? Thanks in advance. Bodengien.
➡️ Reply
#K.E.W by Ruth Montefiore on 2010-03-15 13:33
The black hose pipe connected to this pressure washer has a whole in it. Can it be repaired and if so how please. If not how much will it cost to desptach a replacement to me or where can I purchase this hose pipe? Is it something I can obtain from a builders merchants and if so what size please?I l…...
Show More
➡️ Reply
#K.E.W by MARK on 2010-01-02 19:00
My kew steam cleaner does not have water pressure. It exits the gun but only trickles out. Can you help? Many thanksMark
➡️ Reply
#K.E.W by john farkas on 2011-10-26 18:38
I am looking a the circuit board for my 0840HA hot water pressure washer. Mine burned out, the rest of the machine is nearly new. It would be a shame to trash it. KEW no longer makes this board.
➡️ Reply
#K.E.W by ryan on 2011-04-02 17:51
I have a 1979 kew power washer and am looking for some pump parts or info on where to get parts it is mostly all in good shape put the pump needs work any info would be greatly apresated thanks ryan
➡️ Reply
#K.E.W by Anthony blair rowland on 2012-06-04 19:58
Please can you help i have a kew 1502v it will run fine cold, as soon as i demand heat it runs for 5 seconds and switches off if you switch it on & off,it runs for 5seconds and it will do this all day. what is the solution please
➡️ Reply
#K.E.W by PAUL GALLAGHER on 2008-11-17 21:50
HI,I HAVE JUST PURCHASED A KEW 38A2VA POWER WASHER. IS IT POSSIBLE TO GET A MANUAL FOR THIS MACHINE? ALSO WHAT GOES IN THE TANK MARKED WITH A SNOWFLAKE?THANKS PAUL.
➡️ Reply
#K.E.W by m j cars on 2011-03-17 11:08
when i turn the machine on it trips the electrick
➡️ Reply
#K.E.W by gary appleton on 2008-06-10 15:53
i need new hose
➡️ Reply
#K.E.W by john farkas on 2011-10-26 18:47
For any KEW products call Chris Gerber in S.C. (877)322-2586. Very knowledgable and helpfull. He is the US service rep.
➡️ Reply
#K.E.W by Murray Smith on 2010-10-09 06:33
I need a instruction manual for a KEW 1502-66 thank you
➡️ Reply
#K.E.W by Bob Schultz III on 2011-08-17 15:47
I need a service manual with part numbers and specifacation please.
➡️ Reply
#K.E.W by Odyssey Winery on 2010-08-23 21:14
I have a KEW pressure washer, model 0840HA. I am receiving intermittant F2 error codes and C4 error codes. I have taken it into my dealer for \"repair\" however the problem continues. Any ideas?
➡️ Reply
#K.E.W by angelineadlecraft@gmail.com on 2019-05-02 14:02
Good dayI am trying to find a manual to assist me with the heating system of a K.E.W. 38A2VA.Many thanks
➡️ Reply
#K.E.W by ken Tucker on 2008-05-01 16:53
My KEW 1502v-66 is smoking badly and does not get hot. I think the diesel is not burning right. There is a blue flame between the contacts.
➡️ Reply
#K.E.W by gary case on 2010-09-23 15:00
we can\'t get water flow through the machine
➡️ Reply
#K.E.W by Chris bolton on 2009-07-10 15:22
My Kew is not building up pressure can you tell me why please
➡️ Reply
#K.E.W by sandy stevens on 2009-09-28 13:03
Is there anyway to get a takedown of the pump on my kew steam cleaner the model # 08022-56? A parts book would be good.
➡️ Reply
#K.E.W by CESAR ALCAZAR on 2011-04-18 14:09
Hi I have a Heated Pressure Washer, and Im lookin for a specific part can you tell me if ispossible to found it. Lelow information of the machineMAKER: KEWMODELL: 3803V-103SER:2103205ASSET:43-1-5
➡️ Reply
#K.E.W by thomas thorn on 2009-05-03 09:24
The temprature regulator on the top of the washer is broken off next to the gauge i need a new part
➡️ Reply
#K.E.W by TOBY ANDERSON on 2014-08-15 17:47
I have a kew alto 2340ha Everything was working and the usint up and quit It showed a 0 flashing and I unplougged it and put it back it reset to solid 0 but when you push the power on it does nothing. I let sit unplugged but nothing works now. Is there anyone who works on these anymore I am in Wisco…...
Show More
➡️ Reply
#K.E.W by shaban limani on 2011-07-02 17:12
JA ICSH BIN LIMANI CSHABAN ICSH BRAUCHE EINE PUMP MACSHINE FOR AUTO VACSH MACSHINE IST FOR MARKE K.E.W 1502V ICSH CHAP MACSHINE ABER PUMP IST KAPUT BITEIN MAINE EMAIL CSHIKENSI DI VORT FOR MAINE RESPEKT
➡️ Reply
#K.E.W by ali on 2009-05-31 05:45
I\'m looking for the maintenance manual for this machine
➡️ Reply
#K.E.W by J.den Dekker on 2011-04-03 06:34
Geachte meneer/mevrouw,Ik heb heb kew 1500 hogedruk spuitpart nr. 6137219 Serial nr. 6998760.Kunt u mij vertellen of ik een terrascleaner kan krijgen voor deze hogedruk spuit en als dat mogelijk is kunt u mij vertellen waar en wat hij kost.vr.gr.J.den Dekker
➡️ Reply
#K.E.W by Blair on 2007-08-15 01:10
call windy city equipment located in Elgin, Illinois
➡️ Reply
#K.E.W by holmeside garage lee scott on 2012-02-13 22:01
i have a kew 1640ha which i am having a bit trouble with reacently when whent to use it it cum up with the fault L1 and now the machine will not start,i was wundering if you could give me a bit help THANKS
➡️ Reply
#K.E.W by Brent C. on 2012-10-02 22:26
No fuel getting to burner, need manual for test procedure. Thank you, Brent C.
➡️ Reply
#K.E.W by lyndon hammill on 2006-11-06 19:24
All the lights on the temp gauge lit means that the fuel tankis empty. If there is fuel in the tank, there may not be enoughto activate the tank sensor. put more fuel in.If the tank is full,the tank sender is faulty. It will need replacing.In the meentime you can bypass the tank sender by shorting o…...
Show More
➡️ Reply
#K.E.W by Grant Neeley on 2012-01-24 13:44
I have a KEW 23A2V pressure washer that the boiler Coil is completely shot now. I have welded some hole back together, but now it is beyond repair. Does anyone know where I can get a replacement coil?
➡️ Reply
#K.E.W by ken williams on 2011-11-08 03:02
Hi would you have a service manual for this cleaner??
➡️ Reply
#K.E.W by Len on 2009-10-23 14:28
I have a copy of the users instruction book for this machine if you are still in need.
➡️ Reply
#K.E.W by hans on 2009-05-13 16:54
i can\'t get pressure on my kew 1640H. But i have seen that there are watercristals in the pressuremeter. Does someone know what the problem is?Thanks
➡️ Reply
#K.E.W by Ron on 2010-10-12 02:52
My coil froze last winer when heater broke in shop over weekend , do you have any coils
➡️ Reply
#K.E.W by LIMANI on 2010-08-08 21:44
guten abent icsh bin limani cshaban aus macedonia icsh brauche eine tail for meine macshine das chaist pumpe for k.e.w.1502 iat mit drei klipen un federen und kenzi zaigen prais bite
➡️ Reply
#K.E.W by Tom Duclos on 2016-05-31 14:22
Need transformer for above unit part number #3819901 can you help me..
➡️ Reply
#K.E.W by Jesus on 2019-10-11 08:59
Hi I have a KEW 1502v and some body stolen parts so I put all back together but for any reason it not working the heater and I suspected it about the wiring position, and the pressure is stopping and not keep spraying and some times work fine but some times not, one time I fix only with a new clamp …...
Show More
➡️ Reply
#K.E.W by steve oliveros on 2011-06-24 22:12
i need a parts list so i could repair the pump
➡️ Reply
#K.E.W by steve oiveros on 2011-06-20 23:33
I need a parts schematic so I could repair the pump I need the seals kit.
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.